Electrolux EOB9851XAX User Manual download pdf (Page 56)

When the cleaning is completed, do the

above steps in the opposite sequence.

Install the smaller panel first, then the

larger and the door.

WARNING!

Make sure that the glasses

are inserted in the correct

position otherwise the

surface of the door may

overheat.

12.11 Replacing the lamp

WARNING!

Risk of electric shock.

The lamp can be hot.

1. Turn off the oven.

Wait until the oven is cooled down.

2. Disconnect the oven from the mains.

3. Put a cloth on the bottom of the

cavity.

The top lamp

1. Turn the lamp glass cover to remove

it.

2. Remove the metal ring and clean the

glass cover.

3. Replace the lamp with a suitable 300

°C heat-resistant lamp.

4. Attach the metal ring to the glass

cover.

5. Install the glass cover.

The side lamp

1. Remove the left shelf support to get

access to the lamp.

2. Use a Torx 20 screwdriver to remove

the cover.

3. Remove and clean the metal frame

and the seal.

4. Replace the lamp with a suitable 300

°C heat-resistant lamp.

5. Install the metal frame and the seal.

Tighten the screws.

6. Install the left shelf support.

13. TROUBLESHOOTING

WARNING!

Refer to Safety chapters.

13.1 What to do if...

Problem Possible cause Remedy

You cannot activate or op‐

erate the oven.

The oven is not connected

to an electrical supply or it

is connected incorrectly.

Check if the oven is cor‐

rectly connected to the

electrical supply (refer to

the connection diagram if

available).

The oven does not heat

up.

The oven is turned off. Turn on the oven.

www.electrolux.com56

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 62 63 64

Comments to this Manuals

No comments