Electrolux EQBM60AS User Manual download pdf (Page 22)

22 choosing a location/installation warnings electrolux en:tice barbecue

7. Turndownadjustment

When converting to natural gas the turndown setting

will need to be adjusted to give a satisfactory ame

on low setting.

• Remove all knobs from valve shafts

• Using a Phillips head screw driver, fully screw in

clockwise the valve rotation limit screw. When this is

done the valve rotation will be limited to less than 180°.

• Repeat this for all valves

• Following connection of the gas and leak testing as

per previous steps, light all burners and set to high.

• One burner at a time turn the valve shaft to lowest

setting, observe the ame to ensure a small steady

ame is achieved.

• Turn burners off and replace control knobs.

• The vertical clearance above the cooking surface to

any combustible materials must be at least 1000mm.

• Cooking with roasting hood closed vents the hot

ue gases out the rear of the appliance. A minimum

clearance of 450mm to any combustible materials is

required. This clearance should also be maintained for

brittle materials which may be affected, such as glass.

• Avoid windy conditions as this will affect cooking

performance and burner efciency. If this situation

cannot be avoided some shielding may be necessary.

• The barbecue grills and hotplates are slightly sloped

to enable grease & oil drainage into front receptacles.

When choosing a location ensure that the slope

towards the front is maintained. If not, oil & grease

may run into the back of the burner box from the

grill channels.

• This appliance must be installed in accordance with

Australian Standards AS4557 and AS5601 and in

accordance with the local authority.

Choosing a location

valve rotation limit screw

warning

• This appliance shall only be used in an above ground,

open air situation with natural ventilation without

stagnant areas, where gas leakage and products of

combustion are rapidly dispersed by wind or natural

convection. This barbecue has been designed for

outdoor use only. Refer to diagrams below.

• Never install this barbecue inside any building, garage,

shed or breezeway or inside a boat, caravan or

recreational vehicle. This is to prevent the possibility of

re or carbon monoxide poisoning or asphyxiation.

• Any enclosure in which this appliance is installed shall

comply with one of the following:

– An enclosure with walls on all sides, but at least

one permanent opening at the ground level and no

overhead covering.

– Within a partial enclosure that includes an overhead

cover and no more than 2 walls.

– Within a partial enclosure that includes an overhead

cover and more than 2 walls, the following shall apply:

– at least 25% of the total wall area is completely

open and at least 30% of the remaining wall area

is open and unrestricted

• In the case of balconies, at least 20% of the total of

the side, back and front wall areas shall be and remain

open and unrestricted.

Outdoor area example 1

Outdoor area example 2

Outdoor area example 3

Outdoor area example 4

Outdoor area example 5

Installation warnings

both ends

open

open side at

least 25% of

total wall area

30% or more

in total of the

remaining wall

area is open and

unrestricted

open side at

least 25% of

total wall area

30% or more

in total of the

remaining wall

area is open and

unrestricted

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28

Comments to this Manuals

No comments

Electrolux EQBM60AS User Manual Page 22

Comments to this Manuals

Related products and manuals for Unknown Electrolux EQBM60AS