Electrolux ERP34901X User Manual download pdf (Page 10)

Problem Possible cause Solution

Water flows on the

ground.

The melting water outlet

does not flow in the evap-

orative tray above the

compressor.

Attach the melting water

outlet to the evaporative

tray.

The temperature in

the appliance is too

low.

The temperature regulator

is not set correctly.

Set a higher temperature.

The temperature in

the appliance is too

high.

The temperature regulator

is not set correctly.

Set a lower temperature.

6.1 Replacing the lamp

1

2

1.

Switch off the appliance.

2.

Press on the rear hook and at the

same time slide the cover in the direc-

tion of the arrow.

3.

Replace the lamp with one of the

same power and specifically designed

for household appliances. (the maxi-

mum power is shown on the lamp

cover).

4.

Slide the lamp cover into its original

position.

5.

Switch on the appliance.

6.

Open the door. Make sure that the

light comes on.

6.2 Closing the door

1.

Clean the door gaskets.

2.

If necessary, adjust the door. Refer to

"Installation".

3.

If necessary, replace the defective

door gaskets. Contact the Service

Center.

7. INSTALLATION

WARNING!

Read the "Safety Information"

carefully for your safety and cor-

rect operation of the appliance

before installing the appliance.

7.1 Positioning

Install this appliance at a location where

the ambient temperature corresponds to

the climate class indicated on the rating

plate of the appliance:

Cli-

mate

class

Ambient temperature

SN +10°C to + 32°C

N +16°C to + 32°C

ST +16°C to + 38°C

T +16°C to + 43°C

10

www.electrolux.com

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 55 56

Comments to this Manuals

No comments