Electrolux EW6F4842AB User Manual download pdf (Page 21)

Make sure that the flap does not cause a

blockage when you close the drawer.

10.5 Setting a programme

1. Turn the programme dial to select the

desired washing programme.

The indicator of the Start/Pause

button flashes.

The display shows an indicative

programme duration.

2. To change the temperature and/or

the spin speed, touch the related

buttons.

3. If desired, set one or more options by

touching the related buttons. The

related indicators illuminate on the

display and the given information

changes accordingly.

If a selection is not possible

an acoustic signal sounds.

10.6 Starting a programme

Touch the Start/Pause button to start

the programme.

The related indicator stops flashing and

stays on.

The programme starts, the door is

locked. The display shows the indicator

.

The drain pump can operate

shortly before the appliance

fills water.

10.7 Starting a programme with

the delay start

1. Touch the Delay Start button

repeatedly until the display shows the

desired delay time. On the display the

indicator shows .

2. Touch the Start/Pause button. The

appliance door locks and starts the

countdown of the delay start. The display

shows the indicator .

When the countdown is completed, the

programme starts automatically.

Cancelling the delay start after

the countdown has started

To cancel the delay start:

1. Touch the Start/Pause button to

pause the appliance. The related

indicator flashes.

2. Touch the Delay Start button

repeatedly until the display shows

and the indicator goes off.

3. Touch the Start/Pause button

again to start the programme

immediately.

Changing the delay start after

the countdown has started

To change the delay start:

1. Touch the Start/Pause button to

pause the appliance. The related

indicator flashes.

2. Touch the Delay Start button

repeatedly until the display shows the

desired delay time.

3. Touch the Start/Pause

button

again to start the new countdown.

10.8 The SensiCare System

load detection

After touching the Start/Pause

button:

1. The SensiCare System starts

estimating the weight of the load to

calculate the real programme

duration. During this phase the Time

Manager bars placed below the

time digits play a simple animation.

ENGLISH 21

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 35 36

Comments to this Manuals

No comments