Electrolux EWS106430W User Manual

EWS 106430 W... ...EN WASHING MACHINE USER MANUAL

SELECT THE REQUIRED PROGRAMMEBY TURNING THE PROGRAMMESELECTOR DIAL (1)Turn the programme selector dial to the re-quired programme. The washing machine

START THE PROGRAMME BYPRESSING BUTTON 8To start the selected programme, press thebutton 8, the green pilot light of the button8 stops blinking.To inte

AT THE END OF THE PROGRAMMEThe machine stops automatically. Threeblinking 0.00 appear on the display and thepilot light of button 8 goes off. Someacou

acetic acid; treat any residual marks onwhite fabrics with bleach and then rinsethoroughly.Tar stains: first treat with stain remover,methylated spiri

ProgrammeMaximum and Minimum TemperatureCycle DescriptionMaximum Spin SpeedMaximum Fabrics LoadType of LaundryOptionsDetergentCompartmentSYNTHETICS60°

ProgrammeMaximum and Minimum TemperatureCycle DescriptionMaximum Spin SpeedMaximum Fabrics LoadType of LaundryOptionsDetergentCompartmentSOAK30°Prewas

ProgrammeMaximum and Minimum TemperatureCycle DescriptionMaximum Spin SpeedMaximum Fabrics LoadType of LaundryOptionsDetergentCompartmentCOTTONS ECONO

CONSUMPTION VALUESThe data of this table are approximate. Different causes can change the data: thequantity and type of laundry, the water and ambient

Important! Do not use methylated spirits,solvents or similar products to clean thecabinet.CLEANING THE DISPENSER DRAWERThe detergent dispenser drawer

1. Open the pump door.2. Put a container below the recess of thedrain pump to collect the water thatflows out.3. Press the two levers and pull forward

Electrolux. Thinking of you.Share more of our thinking at www.electrolux.comCONTENTSSafety information 2Safety instructions 3Product description

refitting the pump cover, ensure it is se-curely re-tightened so as to stop leaks andyoung children being able to remove it.CLEANING THE WATER INLETFI

WHAT TO DO IF…Certain problems are due to lack of simplemaintenance or oversights, which can besolved easily without calling out an engi-neer. Before

Problem Possible cause/SolutionThere is water on the floor:Too much detergent or unsuitable detergent (creates too muchfoam) has been used.• Reduce th

If you are unable to identify or solve theproblem, contact our service centre. Beforetelephoning, make a note of the model, se-rial number and purchas

3. Unscrew the three bolts.4. Slide out the relevant plastic spacers.5. Open the porthole. Remove the poly-styrene block fitted on the door seal.Remov

2. Do not place the inlet hose downwards.Angle the hose to the left or right de-pending on the position of your watertap.3. Set the hose correctly by

collection point for the recycling of electricaland electronic equipment. By ensuring thisproduct is disposed of correctly, you willhelp prevent poten

electrolux 27

www.electrolux.com/shop 132949502-A-062013

• Obey the maximum load volume of 6 kg (refer to the “Pro-gramme chart” chapter).• If the supply cord is damaged, it must be replaced by themanufactur

• Before you connect the appliance to newpipes or pipes not used for a long time,let the water flow until it is clean.• The first time you use the app

DETERGENT DISPENSER DRAWER Compartment for detergent used forprewash and soak phase or for stain re-mover used during the stain action phase (ifavaila

CONTROL PANELBelow is a picture of the control panel. It shows the programme selector dial as well asthe buttons, pilot light and the display. These a

DELAY STARTThe programme can be delayed from 30min - 60 min - 90 min, 2 hours and then by1 hour up to a maximum of 20 hours bymeans of this button.STA

part of the display. After having pressedbutton 8 only the icon of the running phasestays on.7.3: Heating phaseDuring the washing cycle the display sh

PERSONALISATIONACOUSTIC SIGNALSThe machine is provided with an acousticdevice, which sounds in the following ca-ses:• at the end of the cycle• if ther