Electrolux EWW126410W User Manual download pdf (Page 23)

5. Refit the emergency emptying cap into

the filter and screw the water inlet hose

back.

6. When you intend to start the machine up

again, make sure that the room temper-

ature is above 0°C.

Important! Every time you drain the water

through the emergency emptying hose you

must pour 2 litres of water into the main wash

compartment of the detergent drawer and

then run the drain programme. This will

activate the ECO Valve device avoiding that

part of the detergent remains unused at next

washing.

What to do if…

Certain problems are due to lack of simple

maintenance or oversights, which can be

solved easily without calling out an engineer.

Before contacting your local Service Centre,

please carry out the checks listed below.

During machine operation it is possible that

the red pilot light of button 8 blinks, one of

the following alarm codes appears on the

display and some acoustic signals sound ev-

ery 20 seconds to indicate that the machine

is not working:

•

: problem with the water supply.

•

: problem with the water draining.

•

: door open.

Once the problem has been eliminated,

press the button 8 to restart the programme.

If after all checks, the problem persists, con-

tact your local Service Centre.

Problem Possible cause/Solution

The washing machine does

not start:

The door has not been closed. E40

•Close the door firmly.

The plug is not properly inserted in the power socket.

• Insert the plug into the power socket.

There is no power at the socket.

• Please check your domestic electrical installation.

The main fuse has blown.

• Replace the fuse.

The selector dial is not correctly positioned and the button 8 has not

been pressed.

•

Please turn the selector dial and press the button 8 again.

The delay start has been selected.

• If the laundry are to be washed immediately, cancel the delay start.

The Child Safety Lock has been activated.

• Deactivate the Child Safety Lock.

The machine does not fill:

The water tap is closed. E10

•Open the water tap.

The inlet hose is squashed or kinked. E10

• Check the inlet hose connection.

The filter in the inlet hose is blocked. E10

• Clean the water inlet hose filter.

The door is not properly closed. E40

•Close the door firmly.

The machine fills then emp-

ties immediately:

The end of the drain hose is too low.

• Refer to relevant paragraph in «water drainage» section.

electrolux 23

1 ... 22 23 24 ... 32

Comments to this Manuals

No comments

Electrolux EWW126410W User Manual Page 23

Comments to this Manuals

Related products and manuals for Washing machines Electrolux EWW126410W