Electrolux EWX14450W User Manual download pdf (Page 38)

38 electrolux installation

3. Set the hose correctly by loosening

the ring nut.

After positioning the inlet hose, be

sure to tighten the ring nut again to

prevent leaks.

4. Connect the hose to a tap with a 3/4”

thread. Always use the hose supplied

with the appliance.

The inlet hose must not be lengthened.

If it is too short and you do not wish to

move the tap, you will have to

purchase a new, longer hose specially

designed for this type of use.

Water-stop device

The inlet hose is provided with a water

stop device, which protects against

damage caused by water leaks in the

hose which could develop due to

natural ageing of the hose. This fault is

shown by a red sector in the window

«A». Should this occur, turn the water

tap off and refer to your Service Centre

to replace the hose.

A

P0352

P0351

Water drainage

The end of the drain hose can be

positioned in three ways:

Hooked over the edge of a sink

using the plastic hose guide supplied

with the machine. In this case, make

sure the end cannot come unhooked

when the machine is emptying. This

could be done by tying it to the tap

with a piece of string or attaching it to

the wall.

In a sink drain pipe branch. This

branch must be above the trap so that

the bend is at least 60 cm above the

ground.

Directly into a drain pipe at a height

of not less than 60 cm and not more

than 90 cm. The end of the drain hose

must always be ventilated, i.e. the

inside diameter of the drain pipe must

be larger than the outside diameter of

the drain hose.

The drain hose must not be kinked.

P1118

P0022

132961190.qxd 01/09/2008 9.00 Page 38

Downloaded From WashingMachine-Manual.com Manuals

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 44

Comments to this Manuals

No comments