Electrolux HFW41L8140 User Manual download pdf (Page 18)

10.10 Cancelling a running

programme

1. Press the button for some

seconds to cancel the programme

and to deactivate the appliance.

2. Press the same button again to

activate the appliance. Now, you can

set a new washing programme.

Before starting the new

programme the appliance

could drain the water. In this

case, make sure that the

detergent is still in the

detergent compartment, if

not fill the detergent again.

10.11 Opening the door

CAUTION!

If the temperature and level

of the water in the drum are

too high and the drum still

rotates, you cannot open the

door.

While a programme or the delay start

operates, the appliance door is locked

and the display shows the indicator .

Open the appliance door when the

programme or the delay start

operates:

1. Press

to pause the appliance.

2. Wait until the door lock indicator

goes off.

3. Open the door.

4. Close the door and press again .

The programme or delay start continues

to operate.

10.12 At the end of the

programme

• The appliance stops automatically.

• The acoustic signal operates (if it is

activated).

• In the display comes on.

• The indicator of the

goes off.

• You can open the door.

• Remove the laundry from the

appliance. Make sure that the drum is

empty.

• Close the water tap.

• Press the button for some seconds

to deactivate the appliance.

• Keep the door ajar, to prevent the

mildew and odours.

The washing programme is

completed, but there is water in the

drum:

• The drum turns regularly to prevent

the creases in the laundry.

• The door lock indicator is on. The

door stays locked.

• You must drain the water to open the

door.

To drain the water:

1. Press

. The appliance drains the

water and spins.

2. To make the appliance drain only, set

. If necessary, decrease the

spin speed.

3. Press the button for some

seconds to deactivate the appliance.

The appliance drains and

spins automatically after

approximately 18 hours

(except for Wool

programme).

10.13 AUTO Stand-by option

The AUTO Stand-by function

automatically deactivates the appliance

to decrease the energy consumption

when:

• You do not use the appliance for 5

minutes before you press .

Press the button to activate the

appliance again.

• After 5 minutes from the end of the

washing programme

Press the button to activate the

appliance again.

The display shows the end of the last

set programme.

Turn the programme knob to set a

new cycle.

www.electrolux.com18

1 ... 17 18 19 ... 28

Comments to this Manuals

No comments