Electrolux EASYALU User Manual download pdf (Page 12)

Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer.

The dishwasher is fitted with an alarm system which can help you to quickly determine the cause of any problems.

The dishwasher will not start or stops during operation, all push buttons are inoperative except for the On/Off push button and the

indicator light of the running programme is flashing.

Press the On/Off push button to switch off the dishwasher and carry out the following suggested corrective actions listed below.

Something not working

Symptom Fault code Solution

The machine will not start ● The door has not been properly closed.

● The plug is not properly inserted in the power socket.

● There is a power failure.

The machine does not fill Running programme

● Ensure the water tap is open.

with water indicator light flashes ● Ensure the mains water supply has not been cut off.

● The inlet hose may be squashed or bent. Reposition the hose.

● The inlet hose may be blocked. Switch off the water supply and

clean the filter.

The dishwasher will not drain Running programme

● The drain hose may be squashed or bent. Reposition the hose.

indicator light flashes ● The sink may be blocked. Clear any blockages.

● The drain hose extension is not correct. Follow the instructions for

connecting to the waste.

● There is no vent in the end of the drain hose.

General Running programme

● Switch off the dishwasher. Switch it back on and start the

indicator light flashes programme.

If the alarm reappears, call the local Service Force Centre.

The machine is noisy

● Dishes are rattling against each other, refer to “Loading your

machine”.

● The spray arms are knocking against the dishes. Refer to "Loading

your machine".

The door is difficult to close

● The dishwasher is not level, or not properly built-in.

Visible lime deposits or

● Check that there is salt and that the salt cap is tight.

white film on the dishes ● Check that the right level of the water softener is set.

The dishes are not quite dry

● The rinse aid has run out or too little is being used.

The dishes are not clean

● The baskets are too full.

(poor wash)

● The dishes have not been arranged properly.

● The spray arms do not rotate

● The spray arms are clogged.

● The filters are clogged.

● The filters are not in the correct position.

● Not enough detergent has been used or it is unsuitable.

● The detergent is old or has gone hard.

● The salt container cap is not properly closed.

● The washing programme selected is too gentle.

If after all these checks, the

problem persists, contact

your local Service Force

Centre, quoting the model

and serial number. This

information can be found on

the rating plate located on

the right hand side of the

dishwasher door (see

picture).

Prod.No.

........

Ser. No.

.........

Mod.

........

RA01

1 2 ... 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

Electrolux EASYALU User Manual Page 12

Comments to this Manuals

Related products and manuals for Dishwashers Electrolux EASYALU