SANTO 3151-8 KGRefrigerator/Freezer CombinationOperating Instructions
Installation10Electrical ConnectionAny electrical work required to install this appliance should be carried out by a qualified electrician or competen
11Reversing The Door The door hinges can be changed from right (as supplied) to left if required to suit the location where the appliance is installed
Reversing The Door127. Carefully push refrigerator door onto upper pivot pin and close.8. Slide the centre door bearing into the bottom left of the fr
13Appliance DescriptionView of Applianceá Control panel à Dynamic air cooling systemâ Butter and cheese compartment with lidä Door storage compartment
14Prior to Initial Start-Up1 Before connecting the appliance to the mains and putting it into ope-ration for the first time, leave the appliance to st
Starting Up and Regulating the 15When the ambient temperature in the room where the appliance is situated is lower than +16 °C, the ambient switch mus
16Interior AccessoriesStorage ShelvesThe shelf in the lowest runners above the fruit and vegetable drawer is stopped with plastic corners on the back.
Interior Accessories17Variable Inner DoorThe door compartments can be pulled up and removed, and inserted at other positions as needed.Dynamic Air Coo
18Proper StorageThe cooling fans ensure an even tem-perature distribution in the fridge. Foods with different perishability can therefore be arranged
19To obtain the best performance from your refrigerator/freezer:• Do not store warm food or evaporating liquids.• Do not store food uncovered.• Keep t
2Dear customer,Before placing your new appliance into operation please read these operating instructions carefully. They contain important information
20FreezingWarning! • Before foods are frozen, the actual temperature in the freezer compartment must be -18 °C or colder.• Please observe indicated fr
21Frozen StorageWarning! Before initial loading of the freezer compartment with previously frozen goods, the required storage temperature of -18 °C m
22DefrostingThe Refrigerator is Defrosted AutomaticallyThe rear wall of the fridge compartment covers with frost when the compressor is running, and d
23compartment. In addition, remove pieces of ice that break away before defrosting is complete.5. After defrosting thoroughly clean the freezer interi
24Maintenance and CleaningBefore any maintenance or cleaning work is carried out DISCONNECT the appliance from the ELECTRICITY supply.1 Warning! • Do
Maintenance and Cleaning252 Accumulation of dust at the condenser increases energy consumption. For this reason carefully clean the condenser beneath
26What to do if ...Correcting MalfunctionsA malfunction may be caused by only a minor fault that you can rectify yourself using the following instruct
27If after the above checks there is still a fault, call your local AEG Service Force Centre.In-guarantee customers should ensure that the above check
28Technical Terminology• RefrigerantLiquids that can be used to a generate a cooling effect are known as refrigerants. They have a relatively low boil
29Guarantee ConditionsStandard guarantee conditionsWe, AEG, undertake that if within 12 months of the date of the purchase this AEG appliance or any p
3ContentsContents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3Important Safety Inst
31Service & Spare PartsIn the event of your appliance requiring service, or if you wish to pur-chase spare parts, please contact Service Force by
From the Electrolux Group. The world´s No.1 choice.The Electrolux Group is the world´s largest producer of powered appliances for kitchen, cleaning an
Contents4Freezing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20Frozen Storage . .
51 Important Safety InstructionsThese warnings are provided in the interests of your safety. Ensure that you understand them all before installing or
Important Safety Instructions6Child Safety • Do not allow children to tamper with the controls or play with the product.• Keep packaging material away
7Environmental InformationPackaging All transit packaging materials are environmentally compatible and can be reused. Wood is un-treated. The plastics
8Before Use Packaging 0 1. Remove all adhesive tape and packaging from the interior of the appli-ance.3 Any remnants of adhesive can be removed with
Installation9The following table shows which ambient temperature is correct for each climate classification:If installation next to a source of heat i
Comments to this Manuals