DL 4150CHDL 4150DL 6250570 D5708 DCooker HoodCappa aspiranteCampana extractoraOperating and Installation InstructionsIstruzioni di montaggio ed usoIns
10Fig. 6Warning• Failure to observe the instructions on cleaning the unit andchanging the filters will cause a fire hazard. You are thereforestrongly
11What to do ifIf your appliance fails to work properly please carry out the followingchecks. Symptom Solution The cooker hood will not start... Chec
12Special accessories*Charcoal filter KF8 E-Nr. 942 118 648* Not available in UK, please contact your local Service Force Centre.Technical assistance
13Technical SpecificationsModel:Maximum absorbedpower:Motor absorption:Lighting (E14):Lighting (PL):Length of the cable:Electrical connection:DL415022
14Electrical connection (not for UK)Safety warnings for the electricianBefore connecting the appliance to the power supply, check that thevoltage indi
15Installation - Fig. 8• Drill the base of the wall unit to allow for passage of the hood body.Fig. 7.• Drill the top of the wall unit to allow for pa
16OK!OK!1223-F45-C7667775-CFig. 8
17Removing the hood from cabinetFollow these steps:• Remove the grease filter.• Remove the 4 additional screws from the frame.• Loosen the screws on t
18Relocating the control unit(Only 570 D - 5708 D)The control unit can be fitted at a different point (cladding,lighting facia, etc.).Remove the greas
2Printed on recycled paperAEG - putting words into actionContentsSafety warnings 3For the user 3For the installer 3Description of the Appliance 5Extra
LI13EC Ed. 02/03AEG Hausgeräte GmbHPostfach 1036D-90327 Nürnberghttp://www.aeg.hausgeraete.dehttp://www.aeg.co.uk© Copyright by AEG From the
3Safety warningsFor the user• The cooker hood is designed to extract unpleasant odours from thekitchen, it will not extract steam.• Always cover light
4approximately the same as the outlet hole.• National and regional building regulations impose a number ofrestrictions on using hoods and fuel-burning
5Fig. 2Description of the Appliance• The hood is supplied as an extractor unit and can also be used witha filtering function by fitting one charcoal f
6Fig. 3Light switch0 = Light OFF1 = Light ONMotor switch0 = Motor OFF1 = Speed 1 - Slow2 = Speed 2 -Medium3 = Speed 3 - FastLight switch= Light OFF= L
7Maintenance and care• The hood must always be disconnected from the electricitysupply before beginning any maintenance work.Cleaning the hood• Clean
8Hand washingSoak grease filters for about one hour in hot water with a littlewashing up liquid added, then rinse off thoroughly with hot water.Repeat
9Fig. 5Charcoal filter• The charcoal filter should only be used if you want to use the hoodin the recirculation function.• To do this you will need an
Comments to this Manuals