Electrolux ERN 3420 Specifications download pdf (Page 8)

SOMETHING NOT WORKING

Symptom

No power to the appliance

The light does not come on

The temperature in the fridge

The compressor runs continously

Noise

Water under the salad crispers

Solution

Check there is power at the socket.

Check there is not a power cut by checking the

household lights.

Check the fuse has not blown.

Ensure that the bulb is correctly fitted.

Replace the bulb if it has blown.

Check the door light switch is not jammed.

Check the thermostat control knob in the fridge is

turned to the correct setting relative to ambient

conditions.

Check the ambient temperature is within the

appliance’s operating limits, please refer to the

installation section in this instruction book.

Relocate the appliance if necessary.

Adjust the thermostat control knob to give correct

temperature control. See “Setting the temperature”.

Check that the door is closed.

Large quantities of food have recently been placed in

the cabinet and/or door is frequently opened.

Check that air ventilation is not obstructed.

Refer to normal operating sounds.

Check the drain hole is not blocked. (see

Maintenance and Cleaning).

If the appliance is not working correctly, please carry out the following checks before contacting your local

Service Force Centre

If after the above checks your appliance still does not operate correctly, contact your local Service Force Centre.

Please note that it will be necessary to provide proof of purchase for any in-guarantee service calls.

In-guarantee customers should ensure that the above checks have been made, as the engineer will

make a charge if the fault is not a mechanical or electrical breakdown.

Electrical connections

Any electrical work required to install this appliance

should be carried out by a qualified electrician or

competent person.

WARNING: THIS APPLIANCE MUST BE

EARTHED.

The manufacturer declines any liability should

this safety measure not be observed.

If the plug that is fitted to your appliance is not

suitable for your socket outlet, it must be cut off and

the appropriate plug fitted.

Remove the fuse from the cut off plug.

The cut off plug should then be disposed of to

prevent the hazard of shocks in case it should be

plugged into a 13amp socket in another part of your

home.

Important

The wires in the mains lead are coloured in

accordance with the following code:

Green and Yellow - Earth

Blue - Neutral

Brown - Live

If you fit your own plug, the colours of the wires in

the mains lead of your appliance may not correspond

with the markings identifying the terminals in your

plug, proceed as follows:

Connect the Green and Yellow (earth) wire to the

terminal in the plug which is marked with the letter

«E» or the earth symbol or coloured green and

yellow.

Connect the blue (neutral) wire to the terminal in the

plug which is marked with the letter «N» or coloured

black.

Connect the brown (live) wire to the terminal in the

plug which is marked with the letter «L» or coloured

red.

D207

GREEN & YELLOW

13 AMP. FUSE

BROWN

CORD CLAMP

BLUE

13 AMP

The plug moulded onto the lead incorporates a fuse.

For replacement, use a 13amp BSI362 fuse. Only

ASTA or BSI approved fuses should be used.

The plug must not be used if the fuse cover/carrier is

lost. The cover/carrier is indicated by the coloured

insert at the base of the plug.

A replacement cover/carrier must be obtained from

your local Service Force Centre.

This appliance complies with the E.E.C. Directive

No. 87/308 of 2.6.87 relative to radio interference

suppression.

This appliance complies with the following

E.E.C. Directives:

- 73/23 EEC of 19.2.73 (Low Voltage Directive)

and subsequent modifications;

- 89/336 EEC of 3.5.89 (Electromagnetic

Compatibility Directive) and subsequent

modifications.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Comments to this Manuals

No comments

Electrolux ERN 3420 Specifications Page 8

Comments to this Manuals

Related products and manuals for Fridges Electrolux ERN 3420