Electrolux SB323N User Manual download pdf (Page 8)

GBGB

the bottom of the tray and setting thermostatic control

knob to maximum position can shorten preparing time.

After finishing do not forget to reset the thermostatic con-

trol to the suitable position.

Ready ice cubes can be taken out of the tray under run-

ning water then twist or hit it. If the ice tray freezes to the

compartment, avoid using metal tools or knife to take it out

as the cooling system can be damaged.

Some useful information and

advice

The variable shelves are worth paying attention to,

which increases the usability of the fresh food compart-

ment considerably. Rearranging the shelves is also

possible when the door is open at an angle of 90° .

After opening and closing the door of freezer vacuum

will rise inside the appliance because of the low tem-

perature. So wait 2-3 minutes after closing the door - if

you want to open it again - while inner pressure equalis-

es.

Take care of opening the freezer at a position of ther-

mostatic control so that the inside temperature can

never be warmer than -18°C.

It is practical to make sure of faultless operation of the

appliance daily so as to notice possible failure in time

and prevent deterioration of frozen foods.

Normal operating sounds:

A thermostat controls the compressor and you will

hear a faint click when thermostat cuts in and out.

You may hear faint gurgling or bubbling sound

when the refrigerant is pumped through the coils at

the rear, to the cooling plate/evaporator.

When the compressor is on, the refrigerant is

being pumped round and you will hear a whirring

sound or pulsating noise from the compressor.

The fridge evaporator (this part cool down the

fridge section) is foamed into the cabinet. The tem-

perature of this part changing during its work, and

parallel with this its dimensions are slightly chang-

ing, too. These changes might cause a cracking

noise, which is a natural, harmless phenomenon.

Should you want to check the temperature of food

stored in the refrigerator, set the thermostat knob into a

medium position, place a glass of water centrally in the

cabinet, and put a proper thermometer with an accura-

cy of +/- 1°C into it. If after 6 hours you measure a

value between +3°C and +8°C, the refrigerator works

properly. The measuring shall be performed under

steady-stated conditions (without changing the load).

If the freezer temperature is measured using a ther-

mometer, put it between the products since this will

reflect the real temperature in the frozen products.

Hints and ideas

In this chapter practical hints and ideas are given about

how to use the appliance to reach maximum energy sav-

ing and there is environmental information about the appli-

ance as well.

How to save energy

Avoid putting the appliance in a sunny place near any-

thing that gives off heat.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 18 19

Comments to this Manuals

No comments

Electrolux SB323N User Manual Page 8

Comments to this Manuals

Related products and manuals for Fridges Electrolux SB323N