Electrolux EI30DS55LB Installation Manual download pdf (Page 12)

30" DUAL FUEL SLIDE-IN RANGE INSTALLATION INSTRUCTIONS

(Models with an Electric Oven and a Gas Cooktop)

D. Be sure that all the burner caps and the triple

burner head are correctly placed BEFORE using

your cooktop.

NOTE: There are no burner adjustments necessary on

this cooktop.

10.2

Turn on Electrical Power and Open Main

Shutoff Gas Valve

10.3

Check the Igniters

Operation of electric igniters should be checked after

range and supply line connectors have been carefully

checked for leaks and range has been connected to

electric power. To check for proper lighting:

1. Push in and turn a surface burner knob to the LITE

position. You will hear the igniter sparking.

2. The surface burner should light when gas is available

to the top burner. Each burner should light within

four (4) seconds in normal operation after air has been

purged from supply lines. Visually check that burner

has lit.

3. Once the burner lights, the control knob should be

rotated out of the LITE position.

There are separate ignition devices for each burner. Try

each knob separately until all burner valves have been

checked.

10.4

Adjust the “low” setting for regular surface

burner valves (Figure 16)

Be careful when performing this operation.

a. Push in and turn control to LITE until burner ignites.

b. Quickly turn knob to LOWEST POSITION.

c. If burner goes out, reset control to OFF.

d. Remove the surface burner control knob.

e. Insert a thin-bladed screwdriver into the hollow valve

stem and engage the slotted screw inside. Flame size

can be increased or decreased with the turn of the

screw. Turn counterclockwise to increase ﬂame size.

Turn clockwise to decrease ﬂame size. Adjust ﬂame

until you can quickly turn knob from LITE to LOWEST

POSITION without extinguishing the ﬂame. Flame

should be as small as possible without going out.

Note: Air mixture adjustment is not required on surface

burners.

Figure 16

Dual Valve

Regular

Valve

Hollow

Valve Stem

Clockwise

Decrease Flame

Counterclockwise

Increase Flame

10.5

Adjust the "LOW" Setting of the Dual Burner

Surface Valve (Figure 16)

Note: On the dual valve the low setting of each portion

should be adjusted individually.

a. Push in and turn control to LITE until the rear portion

of the bridge burner ignites only.

b. Quickly turn knob to LOWEST POSITION.

c. If burner goes out, reset control to OFF.

d. Remove the surface burner control knob.

e. The rear or outer portion of the burner ﬂame size

can be increased or decreased with the turn of the

screw A. Use screw B to adjust the ﬂame size of the

center portion of the burner. Turn counterclockwise

the screw to increase ﬂame size. Turn clockwise the

screw to decrease ﬂame size. Adjust ﬂame until you

can quickly turn knob from LITE to LOWEST POSITION

without extinguishing the ﬂame. Flame should be as

small as possible without going out.

Note: Air mixture adjustment is not required on surface

burners.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 43 44

Comments to this Manuals

No comments

Electrolux EI30DS55LB Installation Manual Page 12

Comments to this Manuals

Related products and manuals for Microwaves Electrolux EI30DS55LB