Electrolux EI30DS55LB Installation Manual download pdf (Page 14)

30" DUAL FUEL SLIDE-IN RANGE INSTALLATION INSTRUCTIONS

(Models with an Electric Oven and a Gas Cooktop)

Figure 17

BACK EDGE OF

RANGE LINE OR

REAR WALL

ANTI-TIP

BRACKET

10 ”½

(26.7 cm)

To e

Plate

Door

Cabinet

Kitchen

Cabinet

SLIDE

BACK

1. Draw a center line (CL) on the ﬂoor where the range

should be installed. Also draw a line on the ﬂoor at

the range back position if there is no wall.

2. Unfold paper template and place it ﬂat on the ﬂoor

with the right rear corner positioned exactly on the

intersection of the center and back lines you just drew

before. (Use the diagram below to locate brackets if

template is not available. (Figure 17))

3. Mark on the ﬂoor the location of the 4 mounting

holes shown on the template. For easier installation,

3/16"(0,48 cm) diameter pilot holes 1/2"(1,27 cm)

deep can be drilled into the ﬂoor.

4. Remove template and place bracket on ﬂoor. Line up

holes in bracket with marks on ﬂoor and attach with

4 screws provided. Bracket must be secured to solid

ﬂoor (Figure 18). If attaching to concrete ﬂoor, ﬁrst

drill 3/16"(0,48 cm) dia. pilot holes using masonry drill

bit.

5. Be sure the 4 levelling legs are at the highest position

they can be.

6. Slide range into place making sure structure of the

range is trapped by the anti-tip bracket (Figure 18).

Lower the range by adjusting the 4 levelling legs until

the underside of the cooktop is sitting level on the

countertop. Refer to “Levelling the Range” section.

7. After installation, verify that the anti-tip bracket is

engaged by grasping the top rear edge of the range

and carefully attempt to tilt it forward to make sure

range is properly anchored.

Anti-Tip Brackets Installation

Instructions

To reduce the risk of tipping of the

range, the range must be secured to the ﬂoor by properly

installed anti-tip bracket and screws packed with the

range. These parts are located in the oven. Failure to

install the anti-tip bracket will allow the range to tip over

if excessive weight is placed on an open door or if a child

climbs upon it. Serious injury might result from spilled hot

liquids or from the range itself.

Follow the instructions below to install the anti-tip

brackets.

If range is ever moved to a different location, the anti-

tip brackets must also be moved and installed with the

range.

Tools Required:

Adjustable Wrench

Ratchet

Drill & 1/8"(0,32 cm) bit

5/16" (0,8 cm) Nutdriver

Level

The anti-tip bracket attaches to the ﬂoor at the back of

the range to prevent range from tipping. When fastening

bracket to the ﬂoor, be sure that screws do not penetrate

electrical wiring or plumbing. The screws provided will

work in either wood or concrete.

(

L = Center line)

Figure 18

Range

Anti-Tip Bracket

Floor Mount

Screws

Floor

Rear of Range

Wall

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 43 44

Comments to this Manuals

No comments

Electrolux EI30DS55LB Installation Manual Page 14

Comments to this Manuals

Related products and manuals for Microwaves Electrolux EI30DS55LB