Electrolux EOK96030X User Manual download pdf (Page 36)

Problem Possible Cause Remedy

"d" appears on the dis-

play and the oven does

not heat up in any mode.

Test mode is switched on Switch the appliance off, hold down

and at the same time until

the signal sounds and the "d" on

the display goes out.

If you are unable to remedy the problem

by following the above suggestions,

please contact your dealer or the Cus-

tomer Care Department.

Warning! Repairs to the appliance are

only to be carried out by qualified service

engineers. Considerable danger to the

user may result from improper repairs.

If the appliance has been wrongly oper-

ated, the visit from the customer service

technician or dealer may not take place

free of charge, even during the warranty

period.

Advice on cookers with metal fronts: Be-

cause of the cold surface at the front of

the cooker, opening the oven door dur-

ing (or just after) baking or roasting may

cause the glass to steam up.

Electrical Connection

The oven is designed to be connected to

230-240V~(50Hz) electricity supply.

The oven has an easily accessible terminal

block which is marked as follows:

Letter L - Live terminal

Letter N - Neutral terminal

- Earth terminal

Caution! This oven must be earthed!

The cable used to connect the oven to the

electrical supply must comply to the specifi-

cations given below.

For UK use only

Connection via Min. size Cable/flex Cable/flex type Fuse

Cooker Control Circuit 2,5 mm² PVC/PVC twin and

earth

min: 15 A

max: 20 A

It is necessary that you install a double pole

switch between the oven and the electricity

supply (mains), with a minimum gap of 3 mm

between the switch contacts and of a type

suitable for the required load in compliance

with the current regulations.

The switch must not break the yellow and

green earth cable at any point.

Important! After installation and connecting,

the cable must be placed so that it cannot at

any point reach a temperature of more than

50°C above the ambient temperature.

Before the oven is connected, check that the

main fuse and the domestic installation can

support the load; and that the power supply

is properly earthed.

The manufacturer declines any respon-

sibility should these safety measures

not be carried out.

Installation Instructions

Caution! The new appliance may only

be installed and connected by a

registered installation engineer. Please

comply with this instruction. If you do

not, any damage resulting is not covered

by the warranty.

To prevent future hazards, damaged mains

cables must only be replaced by a qualified

electrician.

Safety information for the installer

• The set-up of the electrical installation is

arranged so that the appliance can be iso-

lated from the mains with a minimum 3mm

all-pole contact separation.

Suitable separation devices include e. g.

cut-outs, fuses (screw fuses are to be tak-

en out of the holder), RCD's and contac-

tors.

36 electrolux

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 47 48

Comments to this Manuals

No comments