Electrolux EOC5H40X User Manual download pdf (Page 31)

3. Close the oven door halfway to the

first opening position. Then lift and

pull forward and remove the door

from its seat.

4. Put the door on a soft cloth on a

stable surface.

5. Hold the door trim (B) on the top

edge of the door at the two sides and

push inwards to release the clip seal.

1

2

B

6. Pull the door trim to the front to

remove it.

7. Hold the door glass panel by its top

edge and carefully pull it out. Make

sure the glass slides out of the

supports completely.

8. Clean the glass panels with water

and soap. Dry the glass panels

carefully. Do not clean the glass

panels in the dishwasher.

When the cleaning is completed, install

the glass panel and the oven door.

The screen-printing zone must face the

inner side of the door. Make sure that

after the installation the surface of the

glass panel frame on the screen-printing

zones is not rough when you touch it.

When installed correctly the door trim

clicks.

Make sure that you install the internal

glass panel in the seats correctly.

A

10.8 Replacing the lamp

WARNING!

Risk of electric shock.

The lamp can be hot.

1. Turn off the oven.

Wait until the oven is cooled down.

2. Disconnect the oven from the mains.

3. Put a cloth on the bottom of the

cavity.

CAUTION!

Always hold the halogen

lamp with a cloth to prevent

grease residue from burning

on the lamp.

The back lamp

1. Turn the lamp glass cover to remove

it.

2. Clean the glass cover.

3. Replace the lamp with a suitable 300

°C heat-resistant lamp.

4. Install the glass cover.

11. TROUBLESHOOTING

WARNING!

Refer to Safety chapters.

ENGLISH 31

1 2 ... 26 27 28 29 30 31 32 33 34 35 36

Comments to this Manuals

No comments