Electrolux EDE1074PDW User Manual download pdf (Page 13)

Displayed programme time

changes erratically or stays un-

changed for a long time.

Programme time is corrected

automatically depending on

type and volume of laundry and

level of dampness.

Automatic process; this is not a

machine fault.

Drying cycle ends shortly after

programme starts.

Not enough washing loaded or

washing loaded is too dry for

selected programme.

Select time programme or

higher drying level (e.g. EXTRA

DRY instead of STORAGE

DRY ).

Drying cycle lasts an unusually

long time. Note: After around 5

hours the drying cycle ends au-

tomatically.

Filter clogged. Clean filter.

Load volume too big. Reduce load volume.

Laundry insufficiently spun.

Laundry must be adequately

spun.

CHANGING THE BULB FOR INTERIOR

LIGHTING

Only use a special bulb which is designed

specially for dryers. The special bulb can be

obtained from your local Service Force cen-

tre.

Warning! When the appliance is

switched on, the interior lighting

switches itself off after 4 minutes when

the door is open.

Warning! Do not use standard bulbs!

These develop too much heat and may

damage the machine!

Warning! Before replacing the bulb,

disconnect the mains plug.

1. Unscrew cover above the bulb (this can

be found directly behind the loading

aperture, at the top; refer to “Descrip-

tion of machine” section.)

2. Replace defective bulb.

3. Screw cover back down.

Check the correct positioning of o-ring gas-

ket before screwing back the door light

cover. Do not operate the dryer when miss-

ing o-ring gasket on door light cover.

Warning! For safety reasons, the cover

must be screwed down tightly. If this is

not done, the dryer must not be

operated.

MACHINE SETTINGS

BUZZER SIGNAL PERMANENT OFF

1. Turn the programme selector to any

programme.

2. Press simultaneously the LONG ANTI-

CREASE

and BUZZER buttons

and hold down for approx. 5 seconds.

3. The buzzer is by default always off. You

can use BUZZER

button to activate

or deactivate sound but machine does

not memorize your selection.

WATER HARDNESS

Water contains, a variable quantity of lime-

stone and mineral salts of which quantities

vary according to geographical locations

thus varying its conductivity values. Rele-

vant variations of the conductivity of the

water compared to those prefixed by the

factory could slightly influence the residual

humidity of the laundry at the end of the cy-

cle. Your dryer allows you to regulate the

sensitivity of the drying sensor based on

conductivity values of the water.

1. Turn the programme selector to any

programme.

2.

Press simultaneously the BUZZER

and START/PAUSE buttons and hold

down for approx. 5 seconds. The cur-

rent setting is on the display:

–

low conductivity <300 micro S/cm,

– medium conductivity

300-600 micro S/cm,

– high

conductivity >600 micro S/cm

3. Press the START/PAUSE button se-

quentially until you set desired level.

4. To memorize setting press simultane-

ously the BUZZER

and START/

PAUSE buttons or turn knob to "O"

(OFF) position

electrolux 13

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 39 40

Comments to this Manuals

No comments