Electrolux EOB5450AAX User Manual download pdf (Page 27)

9. Clean the glass panel with water and

soap. Dry the glass panel carefully.

When the cleaning is completed, do the

above steps in the opposite sequence.

Install the smaller panel first, then the

larger and the door.

WARNING!

Make sure that the glasses

are inserted in the correct

position otherwise the

surface of the door may

overheat.

10.5 Replacing the lamp

Put a cloth on the bottom of the interior

of the appliance. It prevents damage to

the lamp glass cover and the cavity.

WARNING!

Danger of electrocution!

Disconnect the fuse before

you replace the lamp.

The lamp and the lamp glass

cover can be hot.

1. Deactivate the appliance.

2. Remove the fuses from the fuse box

or deactivate the circuit breaker.

The top lamp

1. Turn the lamp glass cover

counterclockwise to remove it.

2. Clean the glass cover.

3. Replace the lamp with a suitable 300

°C heat-resistant lamp.

4. Install the glass cover.

11. TROUBLESHOOTING

WARNING!

Refer to Safety chapters.

11.1 What to do if...

Problem Possible cause Remedy

You cannot activate or op‐

erate the oven. The display

shows “400” and an acous‐

tic signal sounds.

The oven is incorrectly

connected to an electrical

supply.

Check if the oven is cor‐

rectly connected to the

electrical supply (refer to

the connection diagram if

available).

The oven does not heat

up.

The oven is deactivated. Activate the oven.

The oven does not heat

up.

The clock is not set. Set the clock.

The oven does not heat

up.

The necessary settings are

not set.

Make sure that the settings

are correct.

ENGLISH 27

1 2 ... 22 23 24 25 26 27 28 29 30 31 32

Comments to this Manuals

No comments