Electrolux EXD20DN3W User Manual download pdf (Page 5)

5 ENGLISH

3. BEFORE FIRST USE

3.1 Selecting a Location

Important

1. Dehumidier must be operated in an

enclosed area to be most effective.

Close all doors, windows, and other

outside openings to the room. The

effectiveness of the dehumidier

depends on the rate at which new

moisture-laden air enters the room.

2. Place dehumidier in a location that

does not restrict airow through the

front of the unit.

3. A dehumidier operating in a base-

ment will have little or no effect in

drying an adjacent enclosed storage

area, such as a closet, unless there

is adequate circulation of air in and

out of the area. lt may be necessary

to install a second dehumidier in the

enclosed area for satisfactory drying.

4. The dehumidier must be installed on

a level oor that will support it with a

full bucket of water.

5. There should be a minimum of

12 inches clearance around the

dehumidier.

3.2 How It Works

When the unit is started, the fan begins

to pull moisture-laden air across the

dehumidifying coils. The coils condense

or draw moisture from the air, and air

ows into the room as dry, warm air.

Moisture removed from air is collected in

a bucket on the front of the dehumidier.

The unit is designed to operate between

5°C (41°F) and 35°C (96°F). The unit will

not work properly if the temperature is

out of this temperature range, or the per-

formance of the unit will fall greatly. The

“Compressor” circuit has an automatic

3 minute time delayed start if the unit is

turned off and on quickly. This prevents

overheating of the compressor and pos-

sible circuit breaker tripping. Make sure

the tank is tted correctly otherwise unit

will not turn on.

CAUTION!

Avoid Injury or damage to the unit

or other property

• Do not direct airow at replaces or

other heat related sources as this

could cause are ups.

• Do not climb on or place objects on

the unit.

• Do not hang objects off the unit.

• Do not place containers with liquids on

the unit.

• Turn off the dehumidier at the power

source when it will not be used for an

extended period of time.

• Operate the unit with air lter in place.

• Do not block or cover the intake grille,

discharge area and outlet ports.

• Ensure that any electrical/electronic

equipment is one yard away from the

unit.

• Do not use or store ammable gases

near the unit.

4. OPERATING INSTRUCTION

4.1 Connect the Unit to Power

Allow the unit to reach room temperature

before operating.

Unit must be upright for one hour prior to

operating.

To begin operating the dehumidier,

follow these steps:

1. Plug the power cord into a properly

grounded 220-240V AC outlet.

2. If the BUCKET FULL light is on,

remove the bucket and re-install to

reset the oat switch.

1 2 3 4 5 6 7 8 9 10 ... 87 88

Comments to this Manuals

No comments