Electrolux LFG525W User Manual download pdf (Page 3)

3

1. SAFETY WARNING

The minimum distance between the hob surface on which the pans stand

and the lower part of the hood must be 65 cm, unless otherwise speciﬁ ed

in the installation instructions. If the hob installation instructions specify a

greater distance, it must be taken into account.

The air collected must not be conveyed into a duct used to blow off

smokes from appliances fed with an energy other than electricity (central

heating systems, thermosiphons, water-heaters, etc.).

Comply with the ofﬁ cial instructions provided by the competent authorities

in merit when installing the disposal duct. In addition, exhaust air should

not be discharged into a wall cavity, unless the cavity is designed for that

purpose.

The room must be well aerated in case a hood and some other heat

equipment fed with an energy other than electricity (gas, oil, coal heaters,

etc) operate at the same time.

In fact the intake hood, disposing of air, could create a vacuum in the room.

The vacuum should not exceed 0,04mbar. This prevents the gas exhausted

by the heat source from being intaken again. It is therefore advisable to

ensure the room contains air taps able to ensure a steady ﬂ ow of fresh air.

Check the data label inside the appliance; if the symbol (

) is printed, read

the following: this appliance has such technical particulars that it belongs

to class II insulation, therefore it must not be earthed.

Check the data label inside the appliance; if the symbol ( ) is NOT prin-

ted, read the following: ATTENTION: This appliance must be earthed.

When making the electrical connections, check that the current socket has

a ground connection.

When making the electrical connections, check that the voltage values

correspond to those indicated on the data plate inside the appliance itself.

In case your appliance is not ﬁ tted with a supply cord and a plug or with

other means for disconnection from the supply mains having a contact

separation in all poles that provide full disconnection under overvoltage

category III conditions, that means for disconnection must be incorporated

in the ﬁ xed wiring in accordance with the wiring rules. If your unit features

a power lead and plug, position this so the plug is accessible.

Always switch off the electricity supply before carrying out any cleaning

or servicing operations on the appliance.

If the supply cord is damaged, it must be replaced by the manufacturer,

its service agent or similarly qualiﬁ ed persons in order to avoid a hazard.

ENGLISH

1 2 3 4 5 6 7 8 ... 147 148

Comments to this Manuals

No comments