Electrolux EWW148540W User Manual download pdf (Page 11)

Soil Level Icon Type of fabric

Super Re-

fresh

1)

2)

For refreshing a very

few items only

1) We recommend you to reduce the load sizes (see

Washing programmes table).

2) When you select this option the relevant icon appears

just for a while and then it disappears immediately.

Altering an option or a running

programme

It is possible to change some options be-

fore the programme carries them out .

Before you make any change, you must

PAUSE the appliance by pressing the but-

ton 8 (if you wish to change the Time Man-

ager option, you must cancel the running

programme and make your selection again).

Changing a running programme is possible

only by resetting it. Turn the programme se-

lector dial to

and then to the new pro-

gramme position. Start the new programme

by pressing the button 8 again. The wash-

ing water in the tub will be not emptied out.

Interrupting a programme

Press the button 8 to interrupt a pro-

gramme which is running, the correspond-

ing green pilot light starts blinking.

Press the button again to restart the pro-

gramme.

Cancelling a programme

Turn the selector dial to

to cancel a pro-

gramme which is running.

You can select now a new programme.

Opening the door

After the programme has started (or during

the delay time) the door is locked, if you

need to open it, set first the machine to

PAUSE by pressing the button 8 .

If the icon 2.8 disappears after some mi-

nutes, the door can be opened.

If the icon 2.8 does not go off, this means

that the machine is already heating or that

the water level is too high. Do not try to

force the door!

If you cannot open the door but you need

to open it you have to switch the machine

off by turning the selector dial to

. After a

few minutes the door can be opened (pay

attention to the water level and temper-

ature!) .

After closing the door, it is necessary to se-

lect the programme and options again and

to press button 8 .

At the end of the programme

The machine stops automatically. Three

blinking zeros (

) appear on the dis-

play and the pilot light of button 8 goes off.

Some acoustic signals sound for a few mi-

nutes.

If a programme or an option that ends with

water left in the tub has been selected, the

icon 2.8 remains displayed to indicate that

the water must be emptied out before open-

ing the door.

Follow the below instructions to empty out

the water:

1.

Turn the programme selector dial to

.

2. Select the draining or spinning pro-

gramme.

3. Reduce the spin speed if needed, by

pressing the relevant button.

4. Press button 8 .

At the end of the programme, the icon 2.8

disappears and the door can be opened.

Turn the programme selector dial to

to

switch the machine off.

Remove the laundry from the drum and care-

fully check that the drum is empty. If you do

not intend to carry out another wash, close

the water tap. Leave the door open to pre-

vent the formation of mildew and unpleas-

ant smells.

Stand by : once the programme has finish-

ed after a few minutes the energy saving sys-

tem will be enabled. The brightness of the

display is reduced. By pressing any button

the appliance will come out of the energy

saving status.

electrolux 11

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 63 64

Comments to this Manuals

No comments