Electrolux EWX147410W User Manual Page 26

  • Download
  • Add to my manuals
  • Print
  • Page
    / 40
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 25
2. Close the water tap.
3. Place the end of the emergency
emptying hose and that of the inlet
hose in a bowl placed on the floor and
let water flow out of the hoses.
4. Set the Drain programme and let it
operate until the end of the cycle.
5. Turn the programme knob to On/Off
to disconnect the appliance from the
power supply.
6. Screw the water inlet hose back on
and re-fit the emergency emptying
hose after having put the cap on
again.
WARNING!
Make sure that the
temperature is more than 0
°C before you use the
appliance again.
The manufacturer is not
responsible for damages
caused by low temperatures.
14.9 Emergency emptying out
If the appliance does not drain the water,
proceed as follows:
1. Disconnect the mains plug from the
mains socket.
2. Close the water tap.
3. If necessary, wait until the water has
cooled down.
4. Place a bowl on the floor and put the
end of the emergency emptying hose
into the bowl. Remove its cap.
The water should drain by gravity into the
bowl.
5. When the bowl is full, put the cap
back on the emergency hose.
6. Empty the bowl. Repeat the
procedure until water stops flowing
out.
7. Clean the pump if necessary as
previously described.
8. Replace the emergency emptying
hose in its seat after having plugged it.
9. Screw the water inlet hose back on.
15. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
15.1 Introduction
The start of the appliance does not occur
or it stops during operation.
First try to find a solution to the problem
(refer to the table). If not, contact the
Authorised Service Centre.
With some problems, the acoustic
signals operate and the display shows
an alarm code:
- The appliance does not fill with
water properly.
- The appliance does not drain
the water.
- The appliance door is open or
not closed correctly. Please check the
door!
- The mains supply is unstable.
Wait until the mains supply is stable.
- No communication between
electronic elements of the appliance.
Switch off and switch on again.
WARNING!
Deactivate the appliance
before you do the checks.
www.electrolux.com26
Page view 25
1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 39 40

Comments to this Manuals

No comments