Electrolux EI24BC10QS Owner's Manual Page 7

  • Download
  • Add to my manuals
  • Print
  • Page
    / 18
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 6
7
Floor Mount Installation
The anti-tip bracket is to be located on the
floor in the left or right rear corner of the
beverage center as shown in Figure 6.
Step by step instructions for locating
the position of the bracket:
1 Decide where you want to place the
beverage center. Slide it into place, being
careful not to damage the floor, leaving 1"
(2.5cm) of clearance from the rear wall to
allow room for the anti-tip bracket.
2 Raise the rear leveling legs approximately
¼" (6mm) to allow engagement with the
anti-tip bracket. Level the unit by adjusting
all the leveling legs as required. Turning the
leveling leg counterclockwise will raise the
unit and clockwise will lower the unit.
3 Make sure the beverage center is in the
desired location, then mark on the floor the
rear and side corner of the cabinet where
the anti-tip bracket will be installed. If the
Installation
CAUTION
Any finished flooring should be
protected with appropriate material to
avoid damage when moving the unit.
WARNING
TIP OVER HAZARD: One of the
rear cabinet leveling legs must be
engaged under an anti-tip bracket.
installation does not allow marking the rear
corner of the cabinet, then make temporary
lines on the floor marking the front corner of
the cabinet, excluding the drawer. Slide the
beverage center out of the way. From the
temporary line extend the sidewall line back
21½" (54.6cm) as shown in Figure 7.
4 Align the anti-tip bracket to the marks
on the floor so the side of the bracket
lines up with the side of the cabinet
mark, and the "V" notches on the anti-tip
bracket line up with the end of the 21½"
(54.6cm) line (Rear of cabinet line).
5 Fasten the anti-tip bracket to the floor
using the supplied screw. (See Figure 7).
6 Slide the cabinet back into position, making
sure the rear cabinet leveling leg slides
under the anti-tip bracket engaging the slot.
21 1/2"
(54.6cm)
"V" notches
in bracket
"V" notches
in bracket
Side of cabinet line
Front of cabinet line
Rear of
cabinet line
Rear Leveling leg
Screw
Anti-Tip
Bracket
Leveling Leg
Front of
cabinet
21 1/2"
(54.6cm)
Bottom View
of Beverage
Center
Figure 6
Figure 7
Figure 7a
Page view 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 17 18

Comments to this Manuals

No comments