Electrolux E24CM75GSS - Water Reservoir 24 Inch Coffee Maker Service Manual download pdf (Page 35)

IInnssttaallllaattiioonn IInnffoorrmmaattiioonn

2-9

FFiigguurree 22--88.. CCaabbiinneett GGlliiddee TTaabb

IInnssttaalllliinngg tthhee UUnniitt iinn tthhee CCaabbiinneett

While supporting the coffee maker from below, insert it

into the cabinet cutout. As you insert it into the cabi-

net, line up the glides on the appliance with the cabinet

glides. The appliance should glide on the rails when

slight pressure is applied to the front of the coffee

maker. If it does not glide smoothly, check the distance

between the glides again.

As you slide the coffee maker into the cabinet the

locking tab on the glides will engage. (See Figure 2-8)

CCooffffeeee mmaakkeerr RReemmoovvaall

If you need to remove the unit from the cabinet:

1. Disconnect the power plug from the power

receptacle.

2. Press the respective locking tabs on the glides and

remove the appliance, supporting it from below.

CCoonnnneeccttiinngg tthhee PPlluummbbiinngg ((EE2244CCMM7766GGSSS

S))

1. Insert the 3/4” gasket into the 3/4” fitting on the

water supply hose. Make sure it is properly seated.

2. Connect the 3/4” end of the hose to the water inlet

on the back of the coffee maker.

3. Insert the 1/4” gasket into the 1/4” fitting on the

water supply hose. Make sure it is properly seated.

4. Connect the other end (1/4”) of the hose to the

water supply.

Locking Tab

FFiigguurree 22--99.. WWaatteerr CCoonnnneeccttiioonn

Water Supply

Hose

Gasket

Back of Coffee

Maker

Power Cord

Water Inlet

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 81 82

No comments

Electrolux E24CM75GSS - Water Reservoir 24 Inch Coffee Maker Service Manual Page 35