g
21
Once the jug has been removed,
the filter valve prevents coffee from
dripping onto the warming plate.
3
To guarantee uniform coffee
strength it should be stirred in the
coffee jug after preparation.
1
After brewing is finsihed and you
wish to refill immedately water for
an other jug of coffee, switch the
appliance off and allow it to cool
down for a few minutes.
Dealyed start
This functions allows you, to start
brewing at delayed time automati-
cally.
0 Make ready the appliance as
above.
Instead to switch on, progamm the
dealy start time as follows:
0 Press the AUTO button. The pilot
lamp lights up in grenn, «AUTO»
will be shown in the display.
0 Press the PROG button. The pilot
lamp falshes green.
Set the dealy start time required
by
pressing the H and MIN buttons
repeatedly
.
After a few seconds, the day time is
show again in the display and the
pilot lamp stops flashing. The appli-
ance will start brewing at the set
delay start time.
To check/modify the delay start
time, press PROG button again.
3
If you do want to cancel the
delayed start: Press AUTO button,
the appliance switches off.
Aroma control
This function is to obtain a more
strongly-flavoured coffee and is
available after pressing the or
the AUTO button.
0 Press the Aroma control but-
ton to switch on, «AROMA» will be
shown in the display. Press again
to switch off.
Cleaning and Care
1
Unplug the power cord from the
mains socket before cleaning.
0 To clean the filter holder, swing up
the handle and remove the filter
holder (figure 4).
0 To clean the filter valve thoroughly,
activate it several times while it is
being rinsed.
0 Replace filter holder and swing
handle down (figure 4).
0 Clean the appliance with a damp
cloth but never immerse it in
water!
3
Coffee jug and jug lid are dish-
washer proof.
Descaling - making your cof-
fee maker last longer
As a precautionary measure, we
recommend descaling every three
months.
Only use an environmentally
friendly descaler and follow the
instructions on the packet. Please
do not use a descaler with a con-
centrated formic base, or any des-
caler in powder form.
3
We recommend to use only original
decalcifying tabs from Electrolux
(PNC 900 195 537/7).
Fill the water reservoir with water
and only then add the descaler.
Not
vice versa!
Place the coffee jug
with its lid onto the
warming plate
.
Allow the descaler to take effect for
about 15 minutes, then switch the
appliance on. Switch it off when the
descaler solution has finished flow-
ing through. If necessary repeat the
descaling process. Following this,
allow the appliance to run at least
twice with plain water. Thoroughly
rinse the coffee jug, lid and filter
holder under running water, activate
the filter valve repeatedly during the
rinse process.
822_949_474 EKF7000_EX.book Seite 21 Donnerstag, 28. Mai 2009 8:33 20
Comments to this Manuals