Electrolux FHWC3055LSA Use and Care Guide download pdf (Page 5)

Electrical requirements

Itisthecustomer’sresponsibility:

• tocontactaqualiedelectricalinstaller.

• to assure that the electrical installation is

adequate and in conformance with National

Electrical Code, ANSI/NFPA 70 – latest edition*,

or CSA Standards C22.1-94, Canadian Electrical

Code, Part 1 and C22.2 No.0-M91-latest edition**

and all local codes and ordinances.

If codes permit and a separate ground wire is

used,itisrecommendedthataqualiedelectrician

determines that the ground path is adequate.

• Donotgroundtoagaspipe.

• Checkwithaqualiedelectricianifyouarenot

sure range hood is properly grounded.

• Do not have a fuse in the neutral or ground circuit.

IMPORTANT

Save installation instructions for electrical

inspector’suse.

The range hood must be connected with copper

wire only.

The range hood should be connected directly

to the fused disconnect (or circuit breaker) box

through metal electrical conduit.

Wire sizes must conform to the requirements of

the National Electrical Code ANSI/NFPA 70 – latest

edition”, or CSA Standards C22.1-94, Canadian

Electrical Code Part 1 and C22.2 No.0-M91 – latest

edition** and all local codes and ordinances.

A U.L.- or C.S.A.-listed conduit connector must be

provided at each end of the power supply conduit (at

the range hood and at the junction box).

Copies of the standards listed may be obtained

from:

* National Fire Protection Association Batterymarch

Park Quincy, Massachusetts 02269

** CSA International 8501 East Pleasant Valley Road

Cleveland, Ohio 44131-5575

Power requirement:

120V~, 60Hz, 15 or 20A branch circuit

Intended use

• Yourrangehoodisintendedforexhaustoperation

only. This range hood is not recommended to be

used over indoor grills. Do not use it to exhaust

hazardous or explosive materials or vapors.

Parts supplied

No. Part

Qty.

Range hood 1

Upper and lower

chimney

3 Upper bracket 1

Lower bracket 1

Collar 1

Recirculation kit

(optional

accessories)

FHWRKT55LS

Bulb

20W, 120V~,

GU10 (pre-

assembled)

Long screw

(4mm x 32mm)

Wall plug 8

Short screw

(4mm x 12mm)

Wood screw

(4mm x 50mm)

Stainless steel

screw

(3.5mm x 10mm)

Short screw

(3.5mmx8mm)

10’extension

chimney kit

(optional

accessories)

FHW10X55LS

Plantilla

(estarcido)

Assembly template

(stencilled)

Important safety instructions

Installing the hood

00-Elux FHWC3055LSA-Range-Hood-Book-01.indb 5 12/8/10 12:46 PM

1 2 3 4 5 6 7 8 9 10 11 12 13

Comments to this Manuals

No comments

Electrolux FHWC3055LSA Use and Care Guide Page 5

Comments to this Manuals

Related products and manuals for Cooker hoods Electrolux FHWC3055LSA