Electrolux EKK066AAOX User Manual download pdf (Page 20)

20 www.electrolux.com

5.3 Gas connection

Before connecting the appliance

check that the data on the rating plate

afﬁxed to the cooker, correspond to

those of the gas mains.

A label on the back of this handbook

and at the back of the cooker gives

the appliance adjustment conditions,

that is, the type of gas and operating

pressure.

When the ﬁnal connection has been

made, it is essential that a thorough

leak test is carried out on the cooker

and installation.

Ensure that the main connection

pipe does not exert any strain on the

cooker

The appliance must be installed and

serviced by a competent person as

stated in the Gas Safety (Installation

and Use) Regulation Current Editions

and the IEE Wiring Regulations.

Any gas installation must be carried

out by a competent person (GAS SAFE

REGISTER engineer)

to the relevant Gas Standards.

The manufacturer will not accept

liability, should the above instructions

or any of the other safety instructions

incorporated in this book be ignored.

This cooker is designed to be installed

with an appliance ﬂexible connection.

Connection is made to the RC 1/2 (1/2’’

B.S.P.) female threaded located just

below the hotplate level on the rear

right-hand side of the cooker.

• The gas bayonet connector can be

ﬁtted directly behind the appliance or

alternatively adjacent to the appliance.

• If ﬁtted in a cupboard access must be

available to disconnect and connect

the ﬂexible hose.

• It is recommended that a bayonet type

plug in micropoint ﬂexible hose is used.

• Recommended length - 4 feet x 3/8

inch bore.

Note:

For certain types of gas bayonet

connection used, it may not be possible for

the appliance to be pushed fully back to

the wall stops.

Important:

Flexible tubing MUST comply with BS.669

Current Edition.

Attention! If the appliance is going

to be recessed (class 2 subclass 1),

connect it to the gas supply source

using only ﬂexible stainless steel,

seamless pipes in accordance with

the standard.

Attention! If the appliance is going

to be installed free-standing (class

1) and if you use the ﬂexible rubber

hose, it is necessary to follow the

instructions and the ﬁgure given

below:

Attention! On its route, the hose

must not touch any parts where the

over temperature is than 95°C.

Attention! The hose must not be

subject to any kind of torsional

stress or tractive force, there must

be no pinched parts or really sharp

bends.

Attention! It must not touch

anything that can cut, that has

sharp corners, etc.

Attention! The whole length of

the hose must be easy to inspect

in order to keep a check on its

condition.

Attention! It must be replaced

within the date printed on it.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26 27 28

Comments to this Manuals

No comments