Electrolux EI24ID81SS Owner's Manual download pdf (Page 21)

Vapor at Vent

• Water vapor escapes from the vent during the

drying part of cycle. This is normal.

• Spilled rinse aid can cause foam and lead to

overﬂ owing. Wipe up any spills with a damp

cloth.

• Check to see that dishwasher is level. (See

Installation Instructions).

Dishwasher Won’t Run or Fill (error code i10)

• Check to see if circuit breaker is tripped or if a

fuse is blown.

• Check to see if the water supply is turned on

and the pressure of the water supply is not too

low. (Contact your local water company).

• Check to see if the water tap is open and is not

clogged.

• Check to see if cycle is set correctly. (See

Operating Instructions).

• Check to see if the dishwasher is not set for

Delay Start.

• Check and insure the door is closed and

latched.

• Check to see if the ﬁ lter in the inlet hose is not

clogged and is free of kinks and bends.

Dishwasher has an Odor

• Soiled dishes left in dishwasher too long can

create an odor. Use Rinse cycle.

• There will be a “new” smell when ﬁ rst installed.

This is normal.

• Check to see if unit is draining properly. (See

Dishwasher Does Not Drain Properly).

Stains on Tub Interior

• Washing large amounts of dishware with

tomato based soil can cause a pink/orange

appearance. This will not affect performance

and will gradually fade over time. Pre-rinsing

or using the Rinse cycle will reduce the

chance of staining. Using no heat dry option

will lessen staining.

Removing Spots and Film

Hard water can cause lime deposit buildup on the

interior of the dishwasher. Dishes and glasses

may also get spots and ﬁ lm for a number of

reasons. (See Glassware/Flatware Spotted or

Cloudy section). To remove buildup, and ﬁ lm,

clean using the following instructions:

1. Load clean dishes and glasses in normal

manner. Do not load any metal utensils or

silverware.

2. Do not add detergent.

3. Select the NORMAL WASH cycle. Press

START pad. Close and latch the door.

4. Allow dishwasher to run until it starts the

second water ﬁ ll (approximately 10 minutes).

5. Unlatch an and open door and pour 2 cups of

white vinegar into the bottom of dishwasher.

6. Close and latch door and allow cycle to ﬁ nish.

Solutions to Common Problems

Dishwasher Does Not Drain Properly (error

code i20)

• If unit is hooked up to a food waste disposer,

make sure the disposer is empty.

• Check to see if the knockout plug has been

removed from inside the food waste disposer

inlet.

• Check the sink spigot is not clogged.

• Check to see if drain hose is free of kinks and

bends.

• Check to see if the cycle is complete, not in a

pause.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 67 68

Comments to this Manuals

No comments

Electrolux EI24ID81SS Owner's Manual Page 21

Comments to this Manuals

Related products and manuals for Dishwashers Electrolux EI24ID81SS