Electrolux FAVORIT 80820 User Manual download pdf (Page 28)

Operating Instructions

Load Sensing – Sensor Logic

If a wash programme is started even though there are only a few dishes

in the upper and/or lower rack, an intelligent electronic system adjusts

the amount of water and the duration of the wash programme to the

number of dishes. By this means it is possible to wash only a few dishes

quickly and economically. At half load (6 place settings), up to 2 litres

of water and 0.2 kWh of electricity are saved.

Switching Off the Dishwasher

Switch the dishwasher off when the multi-display indicates “0“ for the

remaining programme time and END is illuminated on the programme

progress display.

If the acoustic signal has been switched on there will be a continuous

signal for 5 seconds at the end of the wash programme.

0 1. Press the ON/OFF button.

All indicators will go out.

Hot steam may escape if the door is opened immediately after the end

of the programme.

2. Open the door carefully, as steam may escape.

If the dishwasher is not switched off, the acoustic signal is repeated

after 10 minutes.

Emptying the Dishwasher

• Hot dishes can be sensitive to knocks. The dishes should therefore be

allowed to cool down before removing them from the appliance.

• Leave the dishes in the dishwasher for approx. 15 minutes after the

end of the programme so that they dry better and can cool down.

• Empty the lower rack first, then the upper rack. This will avoid any

water left on the upper rack dripping onto the dishes in the lower

rack and causing water spots.

1 ... 27 28 29 ... 48

No comments

Electrolux FAVORIT 80820 User Manual Page 28