Electrolux GA60LVCN User Manual download pdf (Page 11)

How to activate the acoustic

signal for the end of programme

The appliance must be in programme

selection mode.

1. To enter the user mode, press and

hold simultaneously and until

the indicators , , and start

to flash and the display is blank.

2. Press

• The indicators , and go

off.

• The indicator continues to

flash.

• The display shows the current

setting: = Acoustic signal off.

3. Press to change the setting.

= Acoustic signal on.

4. Press the on/off button to confirm the

setting.

7. OPTIONS

Desired options must be

activated every time before

you start a programme

(except for Multitab).

It is not possible to activate or

deactivate options while a

programme is running.

7.1 Multitab

Activate this option when you use multi-

tablets that integrate the salt, rinse aid and

detergent functions. They can also contain

other cleaning or rinsing agents.

This option deactivates the release of salt.

The salt indicator does not come on.

This option also deactivates the release of

rinse aid but only when the rinse aid

dispenser is deactivated, (rinse aid

indicator does not come on). If the rinse

aid dispenser is activated, rinse aid is

released even with the option Multitab

activated.

With the use of this option the programme

duration is prolonged to increase the

cleaning and drying results with the use of

multi-tablets.

You do not need to activate the option

Multitab every time you start a

programme. Once you have activated the

option it will remain active.

How to activate Multitab

Press .

The related indicator comes on.

7.2 TimeSaver

This option increases the pressure and the

temperature of the water. The washing

and the drying phases are shorter.

The total programme duration decreases

by approximately 50%.

The washing results are the same as with

the normal programme duration. The

drying results can decrease.

How to activate TimeSaver

Press , the related indicator comes on.

If the option is not applicable to the

programme, the related indicator does not

come on or it flashes quickly for a few

seconds and then goes off.

The display shows the updated

programme duration.

8. BEFORE FIRST USE

1. Make sure that the current level of

the water softener agrees with the

hardness of the water supply. If

not, adjust the level of the water

softener.

2. Fill the salt container.

3. Fill the rinse aid dispenser.

4. Open the water tap.

5. Start a programme to remove any

processing residuals that can still be

ENGLISH

11

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Comments to this Manuals

No comments