Electrolux FI23/12V User Manual download pdf (Page 12)

Problem Possible cause Solution

The door is not closed

correctly.

Refer to "Closing the door".

There is too much frost

and ice.

The door is not closed

correctly or the gasket is

deformed/dirty.

Refer to "Closing the door".

The water drainage plug

is not correctly posi‐

tioned.

Position the water drainage

plug in the correct way.

Food products are not

wrapped properly.

Wrap the food products bet‐

ter.

Temperature is set incor‐

rectly.

Refer to "Operation" .

Water flows on the rear

plate of the refrigerator.

During the automatic de‐

frosting process, frost

melts on the rear plate.

This is correct.

Water flows inside the re‐

frigerator.

The water outlet is clog‐

ged.

Clean the water outlet.

Food products prevent

that water flows into the

water collector.

Make sure that food prod‐

ucts do not touch the rear

plate.

Water flows on the floor. The melting water outlet

is not connected to the

evaporative tray above

the compressor.

Attach the melting water out‐

let to the evaporative tray.

The temperature in the ap‐

pliance is too low/too high.

The temperature regula‐

tor is not set correctly.

Set a higher/lower tempera‐

ture.

The door is not closed

correctly.

Refer to "Closing the door".

The food products' tem‐

perature is too high.

Let the food products tem‐

perature decrease to room

temperature before storage.

Many food products are

stored at the same time.

Store less food products at

the same time.

The thickness of the frost

is greater than 4-5 mm.

Defrost the appliance.

The door has been

opened often.

Open the door only if neces‐

sary.

There is no cold air circu‐

lation in the appliance.

Make sure that there is cold

air circulation in the appli‐

ance.

www.electrolux.com12

1 ... 11 12 13 ... 52

Comments to this Manuals

No comments