Electrolux ER9530I User Manual download pdf (Page 9)

Before carrying out any maintenance operations,

including those described in this book, unplug

the appliance from the mains supply.

Warning

This appliance contains hydrocarbons in its cooling

unit; maintenance and recharging must therefore

only be carried out by authorized technicians.

Cleaning the inside

Clean the inside of the appliance and the accesso-

ries with a solution of lukewarm water and bicar-

bonate of soda (one tablespoonful of soda to 4 litres

of water). Rinse and dry thoroughly.

The freezer compartment drawers can be removed

for washing. To remove the drawers, pull them out

until they reach the stop, then lift and withdraw them

from the guides. To refit the drawers, engage them in

the guides then, keeping them tilted, push them

inwards.

Defrosting of the refrigerator

To achieve automatic defrosting of the refrigerator,

the compressor must cut out from time to time. If the

bottom of the compartment becomes covered with

too much frost, turn the thermostat knob slowly

towards a warmer setting until the compressor starts

to cut out periodically.

It is important to periodically clean the defrost water

drain hole in the middle of the refrigerator

compartment channel to prevent the water

overflowing and dripping onto the food inside. Use

the special cleaner provided, which you will find

already inserted into the drain hole.

Important:

Never use sharp metal tools to scrape off frost

from the evaporator as you could damage it.

Do not use a maechanical device or any artificial

means to speed up the thawing process other

than those recommended by the manufacturer.

D037

MAINTENANCE

If this appliance featuring magnetic door seals is

to replace an older appliance having a spring

lock (latch) on the door or lid, be sure to make

that spring lock unusable before you discard the

old appliance. This will prevent it from becoming

a death-trap for a child.

Location

The appliance should be installed well away from

sources of heat such as radiators, boilers, direct

sunlight etc.

For buiding into the kitchen units follow the special

ÒBuilding-inÓ instructions given.

Electrical connection

Before plugging in, ensure that the voltage and

frequency shown on the serial number plate

correspond to your domestic power supply. Voltage

can vary by ±6% of the rated voltage.

For operation with different voltages, a suitably sized

auto-transformer must be used.

The appliance must be earthed.

The power supply cable plug is provided with a

contact for this purpose.

If the domestic power supply socket is not earthed,

connect the appliance to a separate earth in

compliance with current regulations, consulting a

specialist technician.

The Manufacturer declines all responsibility if

the above safety precautions are not observed.

This appliance complies with the following

E.E.C. Directives:

- 87/308 EEC of 2/6/87 relative to radio interference

suppression.

- 73/23 EEC of 19.2.73 (Low Voltage Directive) and

subsequent modifications;

- 89/336 EEC of 3.5.89 (Electromagnetic

Compatibility Directive) and subsequent

modifications.

Important

It must be possible to disconnect the appliance from

the mains power supply; the plug must therefore be

easily accessible after installation

INSTALLATION

1 2 3 4 5 6 7 8 9 10

Comments to this Manuals

No comments

Electrolux ER9530I User Manual Page 9

Comments to this Manuals

Related products and manuals for Fridges Electrolux ER9530I