Electrolux EGD6576NOK User Manual download pdf (Page 5)

2.1 Installation

WARNING!

Only a qualified person must in-

stall this appliance.

• Remove all the packaging.

• Do not install or use a damaged appli-

ance.

• Obey the installation instruction sup-

plied with the appliance.

• Keep the minimum distance from the

other appliances and units.

• Always be careful when you move the

appliance because it is heavy. Always

wear safety gloves.

• Seal the cut surfaces with a sealant to

prevent moisture to cause swelling.

• Protect the bottom of the appliance

from steam and moisture.

• Do not install the appliance adjacent to

a door or under a window. This pre-

vents hot cookware to fall from the ap-

pliance when the door or the window is

opened.

• If the appliance is installed above draw-

ers make sure that the space, between

the bottom of the appliance and the up-

per drawer, is sufficient for air circula-

tion.

• Make sure that the ventilation space of

2 mm, between the worktop and the

front of the below unit, is free. The war-

ranty does not cover damages caused

by the lack of an adequate ventilation

space.

• The bottom of the appliance can get

hot. We recommend to install a non-

combustile separation panel under the

appliance to prevent access to the bot-

tom.

Electrical connection

WARNING!

Risk of fire and electrical shock.

• All electrical connections must be made

by a qualified electrician.

• The appliance must be earthed.

• Before carrying out any operation make

sure that the appliance is disconnected

from the power supply.

• Use the correct electricity mains cable.

• Do not let the electricity mains cable

tangle.

• Make sure the mains cable or plug (if

applicable) does not touch the hot ap-

pliance or hot cookware, when you

connect the appliance to the near sock-

ets

• Make sure the appliance is installed

correctly. Loose and incorrect electricity

mains cable or plug (if applicable) can

make the terminal become too hot.

• Make sure that a shock protection is in-

stalled.

• Use the strain relief clamp on cable.

• Make sure not to cause damage to the

mains plug (if applicable) or to the

mains cable. Contact the Service or an

electrician to change a damaged mains

cable.

• The electrical installation must have an

isolation device which lets you discon-

nect the appliance from the mains at all

poles. The isolation device must have a

contact opening width of minimum 3

mm.

• Use only correct isolation devices: line

protecting cut-outs, fuses (screw type

fuses removed from the holder), earth

leakage trips and contactors.

Gas connection

• All gas connections should be made by

a qualified person.

• Before installation, make sure that the

local distribution conditions (nature of

the gas and gas pressure) and the ad-

justment of the appliance are compati-

ble.

• Make sure that there is air circulation

around the appliance.

• The information about the gas supply is

on the rating plate.

• This appliance is not connected to a

device, which evacuates the products

of combustion. Make sure to connect

the appliance according to current in-

stallation regulations. Pay attention to

requirements regarding adequate venti-

lation.

ENGLISH 5

1 2 3 4 5 6 7 8 9 10 ... 23 24

Comments to this Manuals

No comments