Electrolux EOB8956VAX User Manual download pdf (Page 58)

When the function is active, the lamp is

off.

1. Put 400 ml of water mixed with 3

tablespoons of vinegar (without herbs)

directly into the steam generator.

2. In the menu activate the function:

Steam Cleaning.

The display shows the duration of the

function (33 minutes).

An acoustic signal sounds when the

programme is completed.

3. Touch the display to deactivate the

signal.

4. Wipe the internal surface of the

appliance with a soft sponge.

5. Remove the remaining water from the

steam generator.

6. After cleaning keep the appliance door

open for approximately 1 hour. Wait

until the appliance is dry. To speed up

the drying you can heat up the

appliance with hot air at temperature

150 °C for approximately 15 minutes.

You can get maximum effects of the

cleaning function if you manually clean the

appliance immediately after the function

ends.

Use the function two times if the level of

dirt is high. Make sure that the appliance

is cool before you activate the second

cycle.

12.4 Decalcification of the

Steam generator

1. Put 250 ml of water mixed with 3

tablespoons of vinegar directly into the

steam generator.

2. In the menu choose: Assisted

Cleaning.

3. Activate the function: Decalcification.

The display shows the duration of the

function (15 minutes).

An acoustic signal sounds when the

programme is completed.

4. Touch a sensor field to deactivate the

signal.

5. Remove the remaining water from the

steam generator.

6. Keep the door open for approximately

1 hour to let the appliance dry fully. To

speed up the drying you can heat up

the appliance with hot air at

temperature 150 °C for approximately

15 minutes.

12.5 Removing and installing the

door

You can remove the door and the internal

glass panels to clean it. The number of

glass panels is different for different

models.

WARNING!

Be careful when you remove

the door from the appliance.

The door is heavy.

1. Open the door fully.

2. Fully press the clamping levers (A) on

the two door hinges.

A

A

3. Close the oven door to the first

opening position (approximately 70°

angle).

4. Hold the door with one hand on each

side and pull it away from the

appliance at an upwards angle.

5. Put the door with the outer side down

on a soft cloth on a stable surface.

This is to prevent scratches.

6. Hold the door trim (B) on the top edge

of the door at the two sides and push

inwards to release the clip seal.

1

2

B

7. Pull the door trim to the front to

remove it.

8. Hold the door glass panels on their

top edge one by one and pull them up

out of the guide.

www.electrolux.com58

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 64

Comments to this Manuals

No comments