Electrolux E30DF74GPS5 Operations Instructions download pdf (Page 10)

9.2 Check Operation

Refer to the Use and Care Guide and the Electronic Oven

Control Guide packaged with the range for operating

instructions and for care and cleaning of your range.

Remove all packaging from the oven before testing.

1. Burner Bases and Burner Caps

This range is equipped with sealed burners as shown

(Figure 17). All pieces are at their place. Take note

where they are. Remove all packaging material

located under the Dual Surface burner head. Make

sure the burner is properly aligned and leveled. NOTE:

There are no burner adjustments necessary on this

range.

30" Range

Burner Base

Fixed

Dual Surface

Burner

36" Range

Burner Cap

Fixed Burner Ring

and Burner Base

Regular Burner

Figure 17

2. Turn on Electrical Power and Open Main Shutoff

Gas Valve

3. Check the Igniters

Operation of electric igniters should be checked after

range and supply line connectors have been carefully

checked for leaks and range has been connected to

electric power. To check for proper lighting:

a.Push in and turn a surface burner knob to the LITE

position. All electronic surface ignitors will spark at the

same time. However, only the burner you are turning

on will ignite.

b.The surface burner should light once the flow of gas

reached the surface burner. Each burner should light

within four (4) seconds in normal operation after air

has been purged from supply lines. Visually check that

burner has lit.

c. Once the burner lights, the control knob should be

rotated out of the LITEposition.

There are separate ignition devices for each burner. Try each

knob separately until all burner valves have been checked.

4. Adjust the "LOW" Setting of Regular Burner (see

figure 17) on the Surface Burner Valves (Figure 18):

a. Push in and turn control to LITEuntil burner ignites.

b. Quickly turn knob to LOWEST POSITION.

c. If burner goes out, reset control to OFF.

d. Remove the surface burner control knob and

decorative ring.

e. Insert a thin-bladed screwdriver into the hollow valve

stem and engage the slotted screw inside. Flame size

can be increased or decreased by turning the screw.

Turn counterclockwise to increase flame size. Turn

clockwise to decrease flame size. Adjust flame until

you can quickly turn knob from LITEto LOWEST

POSITIONwithout extinguishing the flame. Flame

should be as small as possible without going out.

Note: Air mixture adjustment is not required on surface

burners.

Figure 18

1 ... 9 10 11 ... 36

Comments to this Manuals

No comments

Electrolux E30DF74GPS5 Operations Instructions Page 10

Comments to this Manuals

Related products and manuals for Microwaves Electrolux E30DF74GPS5