Electrolux EI27BS16JW User Manual download pdf (Page 9)

Adjusting Flipper Mullion Screw

Installation

To adjust the ﬂipper mullion:

1 Loosen the screw located on the ﬂipper mullion

hinge.

2 Adjustippermullionheight.Forproper

connection with the ﬂipper mullion guide, there

should be a separation about the thickness of a

coin (0.060 inches, or 1.5 mm) between the guide

and ﬂipper mullion.

3 Retighten screw.

4 Lift the door while adjusting the washer. To raise

the door, rotate washer clockwise (when viewed

from the bottom). To lower door, rotate washer

counterclockwise (when viewed from the bottom).

5 Retighten the screw, where applicable, ensuring it

is between the spokes of the set washer. Screw

will not be tight, just insert until it is ﬂush with the

hinge.

Adjusting Flipper Mullion Height

Screw (where applicable)

Raising/Lowering Door

NOTE

If after adjusting doors higher the door makes a

popping/clicking sound, remove screw and replace

with the longer one supplied in the handle package.

1 2 3 4 5 6 7 8 9 10 ... 32

No comments

Electrolux EI27BS16JW User Manual Page 9