Electrolux EDI97170W User Manual download pdf (Page 46)

• Condensation efficiency (corrected with fi-

nal humidity) during cupboard dry cotton

cycle with nominal and half load

All the cycles have to be checked in accord-

ance with EN 61121 (Tumble dryers for

household use – Methods for measuring the

performance).

Installation

Important! The appliance must be moved in

vertical position for transport.

Appliance positioning

• It is recommended that, for your conven-

ience, the machine is positioned close to

your washing machine.

• The tumble dryer must be installed in a

clean place, where dirt does not build up.

• Air must be able to circulate freely all round

the appliance. Do not obstruct the front

ventilation grille or the air intake grilles at

the back of the machine.

• To keep vibration and noise to a minimum

when the dryer is in use, it should be

placed on a firm, level surface.

• Once in its permanent operating position,

check that the dryer is absolutely level with

the aid of a spirit level. If it is not, raise or

lower the feet until it is.

• The feet must never be removed. Do not

restrict the floor clearance through deep-

pile carpets, strips of wood or similar. This

might cause heat built-up which would in-

terfere with the operation of the appliance.

Important!

The hot air emitted by the tumble dryer can

reach temperatures of up to 60°C. The ap-

pliance must therefore not be installed on

floors which are not resistant to high temper-

atures.

When operating the tumble dryer, the room

temperature must not be lower than +5°C

and higher than +35°C, as it may affect the

performance of the appliance.

Important! Should the appliance be moved,

it must be transported vertically.

Important! The appliance must not be

installed behind the lockable door, a sliding

door a door with a hinge on the opposite side

to that of the appliance.

Removing transport safety packaging

Caution!

Before use all parts of the transport packag-

ing must be removed.

1. Open loading door

2. Pull off adhesive strips from inside ma-

chine on top of drum.

3. Remove foil hose and polystyrene pad-

ding from the machine.

Drying rack unpacking

Caution! Before appliance use all

packaging parts and drying rack must

be removed from the drum. The inside

of the drum must be clean.

46 electrolux

1 ... 45 46 47 48 49 50 51 52

Comments to this Manuals

No comments