Electrolux TE1120 User Manual download pdf (Page 15)

10. HINTS AND TIPS

10.1 Ecological hints

• Spin the laundry well before drying.

• Do not exceed the load sizes which are

specified in the programs chapter.

• Clean the filter after each drying cycle.

• Do not use fabric softener to wash and

then dry. In the tumble dryer laundry

becomes soft automatically.

• Use distilled water like that used for

steam ironing. If it is necessary, clean

the distilled water before (e.g. with a

coffee filter) to remove any particles.

• Always keep the airflow slots at the

bottom of the appliance clear.

• Make sure there is good airflow where

the appliance is to be installed.

10.2 Adjustment of the

remaining laundry moisture

degree

To change the default degree of the

remaining moisture of the laundry:

1. Turn on the appliance.

2. Wait approximately 8 seconds.

3. Select 1 of available programmes.

4. Push at the same time and hold down

the

Half load and Cupboard

dry buttons.

One of the symbols goes into the view on

the display:

- the maximum dry laundry

- the more dry laundry

- the standard dry laundry

5. Push the Start/Pause button

again and again until you set

necessary degree.

6. To memorise the setting, push at the

same time the Half load and

Cupboard dry buttons for

approximately 2 seconds.

10.3 Deactivating the Reservoir

indicator

The water container indicator is by default

on. It starts to light at the end of the drying

cycle or during the cycle if the water

reservoir is full. If the draining kit is installed

the water container is drained

automatically and indicator can be

permanently off.

To deactivate the indicator:

1. Turn on the appliance.

2. Wait approximately 8 seconds.

3. Select 1 of available programmes.

4. Push at the same time and hold down

the

Half load and Iron dry

buttons.

One of 2 configurations is possible:

• the Reservoir indicator:

is on

and the symbol goes into

the view - the water container

indicator is permanently on

• the Reservoir indicator: is off

and the symbol goes into

the view - the water container

indicator is permanently off

11. CARE AND CLEANING

11.1 Cleaning the filter

At the end of each cycle the symbol

Filter is on the display and you must clean

the filter.

The symbol flashes on the

display - the filter is missing.

The tumble dryer cannot

start.

The filter collects the fluff. The

fluff occurs while the clothes

are dried in the tumble dryer.

To clean the filter:

1. Open the door. Pull the filter.

ENGLISH

15

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Comments to this Manuals

No comments