Electrolux DI80X User Manual download pdf (Page 3)

2. Installation

Remove the base from the packing

With the help of other adults,

carefully recline the fridge to one

of the sides. With someone’s

help, break the base with your

hands. Tilt the refrigerator to the

other side and remove the rest

of the base.

In the back part remove the adhe-

sive tapes and unlock both back

spacers. Leave it in horizontal

position.

Choose the Location

Install your refrigerator in a ventilated location

away from direct sunlight and heat sources (stove,

ovens, etc.) and ammable products.

Do not install your refrigerator unsheltered (open

to weather).

For the denite position of the refrigerator, respect

the minimum distances recommended:

- On top: 10 cm

- Side: 10 cm

- Behind: 10 cm

Check if the spaces left in

the front of the fridge and

in the right side (looking

at the front of the fridge)

are enough to allow com-

plete opening of the door

and crisper drawer.

Leveling

Set the leveling feet to

ensure perfect refrigerator

stability, preventing rocking

movement. Leave frontal

casters rolling freely.

In order to perform the leveling feet must be com-

pletely on the oor.

To better close the door, the product must be

slightly reclined to the back.

The proper functioning of the refrigerator shall

depend on its perfect leveling.

WARNING

Leveling must be performed with closed

doors.

Your refrigerator was developed to use the

leveling feet, which come with it.

Therefore, do not use other feet other than

the original. There are wheels on the upper

back part of your refrigerator to facilitate

movement.

During packaging removal, the feeding cable

will be loose. To avoid damages, attach it

with adhesive tape in the back of the fridge.

After unpacking and leveling, wait at least

two hours before connecting your refrigera-

tor to prevent malfunctioning.

On top

Side

Behind

Electrical Installation

Before turning your fridge on re-

move the transparent protective

wrapping plastic applied on the

control panel in the freezer door.

Before connecting your refrige-

rator, check if the voltage on the

socket where it will be plugged

is equal to the one indicated on

the label next to the plug (on the

power cable) or on the refrigera-

tor ID label.

Be careful not to leave the refrige-

rator over the power cable.

Connect the refrigerator to an

exclusive socket. Do not use

extensions or T-connectors.

For your safety, request an elec-

trician of your trust to check the

condition of the electrical power

system at the location it will be

plugged and for further infor-

mation, contact the Technical

Service.

The socket wires where your

refrigerator will be connected

should be of copper and have

a minimum section of 2.5 mm².

1 2 3 4 5 6 7 8 ... 55 56

Comments to this Manuals

No comments

Electrolux DI80X User Manual Page 3

Comments to this Manuals

Related products and manuals for Unknown Electrolux DI80X