Electrolux E1000 User Manual download pdf

822 90 22-44/rev I

HIDEAWAY MINI-KITCHEN INSTRUCTIONS

LECTRICAL

Sockets for the mini-kitchen.

n authorized electrician should carry out the electrical

nstallation. The sockets should be fitted on the wall at

the back of the sink base (see drawings). The voltage for

both the hotplates and the refrigerator is 230 - 240 V.

ASSEMBLING

irst unpack the base unit and position in front of the place

of installation and provide space around it for assembly.

Check that the electrical connections have been prepared

prior to the installation.

Remove the protection film from the kitchen sink plus the

three screws, (save no. 1) which hold the kitchen sink at

the back edge. Unpack the top unit. Unclip the doors and

put them aside in order not to damage them. Loosen the

six transport screws (save no. 2). Lift up the top unit and

place it on top of the base unit.

Please take extreme care, as the 3 metal runners on

the lower part of the top unit are very sharp.

ear heavy-duty protective gloves for this part of

the installation.

Take care not to displace the sink fitting from its position

on the bottom unit.

Place the top unit level with the front edge of the base unit.

Please note the depth of the top unit is 620 mm and the

bottom is 600 mm. Screw in the three screws that you

saved (no. 1) through the back edge profile. The six transport

screws which you saved (no. 2) should be used to attach

both of the side rails to the sink unit.

In order to do this, use a metall drill with 2,5 mm diameter

and drill through the pre bored holes in the side edge profiles

hrough onto the kitchen sink´s side gables.

Tighten the screws.

Remove the safety metal bar profile that is fitted between

the inner sides of the top unit at the lower front edge and

re-mount the screws.

INAL

SSEMBL

•

Re-hang the doors and if needed, adjust the hinges.

• Connect the plugs in the right wall sockets and test

all functions.

• Check that the safety micro switch cuts the circuit to

the lighting and the hotplates but not to the refrigerator.

• Connect water and run through to check seals are tight.

SAFETY INSTRUCTIONS

The compact kitchen is approved by SEMKO for connection

according to the enclosed instructions. The hotplates effect

1000 W respectively 1200 W may not be increased by

exchange. The top unit has a safety switch for the hot-

plates and light / socket assembly.

The safety switch closes the circuit when the door is shut

and may not be bypassed.

1 2

Summary of Contents

Page 1 - 822 90 22-44/rev I

822 90 22-44/rev IHIDEAWAY MINI-KITCHEN INSTRUCTIONSELECTRICAL-Sockets for the mini-kitchen.An authorized electrician should carry out the electricali

Page 2 - BOTTOM DIAGRAM B

ELECTRICAL INSTRUCTIONSHIDEAWAY MINI-KITCHEN WITH HOTPLATES1. 2 No. 13 amp sockets are required for the base unit.1No. 13 amp socket is required for t