Electrolux FI3301V User Manual download pdf (Page 10)

Problem Possible cause Solution

Water flows on the floor. The melting water outlet

is not connected to the

evaporative tray above

the compressor.

Attach the melting water out‐

let to the evaporative tray.

Temperature cannot be

set.

The FastFreeze or Shop‐

ping Function function is

switched on.

Switch off FastFreeze or

Shopping Function manually,

or wait until the function re‐

sets automatically to set the

temperature. Refer to "Fast‐

Freeze or Shopping Function

function".

The temperature in the ap‐

pliance is too low/too high.

The temperature regula‐

tor is not set correctly.

Set a higher/lower tempera‐

ture.

The door is not closed

correctly.

Refer to "Closing the door".

The food products' tem‐

perature is too high.

Let the food products tem‐

perature decrease to room

temperature before storage.

Many food products are

stored at the same time.

Store less food products at

the same time.

The door has been

opened often.

Open the door only if neces‐

sary.

The Shopping Function

function is switched on.

Refer to "Shopping Function

function".

There is no cold air circu‐

lation in the appliance.

Make sure that there is cold

air circulation in the appli‐

ance.

If the advice does not lead to

the desired result, contact

the nearest Authorised

Service Centre.

7.2 Replacing the lamp

The appliance is equipped with a longlife

LED interior light.

Only service is allowed to replace the

lighting device. Contact your Authorised

Service Centre.

7.3 Closing the door

1. Clean the door gaskets.

2. If necessary, adjust the door. Refer

to "Installation".

3. If necessary, replace the defective

door gaskets. Contact the Authorised

Service Centre.

8. INSTALLATION

WARNING!

Refer to Safety chapters.

www.electrolux.com10

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 59 60

Comments to this Manuals

No comments