Electrolux W 365 B Service Manual download pdf (Page 153)

Service

Manual

67

23

23. Programme unit

438 9145-41/03

03.11

Speed

Default value, extraction time

Here you determine the various speeds (low,

medium and high) for extraction. The instructions

for determining the length of extraction times are to

be found earlier in SETTINGS 2.

How an extraction sequence works:

In order to extract some of the water from the

load at lower speeds, the drum does not

accelerate to its highest speed immediately.

Instead it accelerates in several steps. This

means that the drum first accelerates to a low

speed level, remains at that for a certain time,

then accelerates to a higher level, extracts at

that speed for a certain time, and so on until it

reaches its final (maximum) extraction speed. If

you program a low extraction speed, the number

of steps at the beginning of the extraction

sequence may be reduced.

TIME DELAY BEFORE DOOR OPENING 0:30

UPPER TEMPERATURE FOR ERROR 98°C

LOWER TEMPERATURE FOR ERROR -9°C

MAX ADJUST TEMPERATURE 97°C

MAXIMUM EXTRACT SPEED 1200

DEFAULT WASH SPEED 48

DISTRIBUTION SPEED 90

DEFAULT LOW EXTRACT RPM 550

DEFAULT MEDIUM EXTRACT RPM 700

DEFAULT HIGH EXTRACT RPM 900

START EXTRACT SPEED 1000

DEFAULT WASH ACCELERATION 20

DISTRIBUTION ACCELERATION 9

RETARDATION ACCELERATION

EXTRACT ACCELERATION 40

START EXTRACT ACCELERATION 40

EXTRACT RETARDATION 50

1 2 3

4 5 6

7 8 9

0

Use the numeric keys to

enter the value.

If you make a mistake while

entering digits:

Press ERASE.

When you have finished:

Press .

low

medium

high

Time

Start extract speed (i.e. Initial extraction

speed)

Here you determine the speed of initial extraction.

When you are creating a wash program you can

determine (under ”Main data”) whether it is to

begin with initial extraction. Initial extraction is used

to spin the load outwards against the drum walls,

which makes it absorb water more readily on first

filling. As a result of this the machine will not

require so much extra filling later.

There are two other functions affecting initial

extraction which can be programmed under

SETTINGS 2:

• START EXTRACT TIME

• START EXTRACT ACCELERATION

START EXTRACT SPEED 1000

DEFAULT WASH ACCELERATION 20

DISTRIBUTION ACCELERATION 9

RETARDATION ACCELERATION

EXTRACT ACCELERATION 40

START EXTRACT ACCELERATION 40

EXTRACT RETARDATION 50

MAX SPEED DURING FILLING 100

MAX LEVEL OFFS FOR AUT. CALIB.

TIME AT DISTRIBUTION SPEED 2

NUMBER OF REDIST LOW 1 UNB.

NUMBER OF REDIST LOW 2 UNB.

NUMBER OF REDIST MEDIUM UNB.

NUMBER OF REDIST HIGH UNB.

NUMBER OF REDIST EXTREME UNB.

DRAIN TIME AT PROGR. START

DRAIN TIME AT PROGR. END

READY

1 2 3

4 5 6

7 8 9

0

Use the numeric keys to

enter the value.

If you make a mistake while

entering digits:

Press ERASE.

When you have finished:

Press .

1 ... 152 153 154 ... 240

Comments to this Manuals

No comments