Electrolux EWF147110W User Manual download pdf (Page 23)

2. The other end of the inlet hose which

connects to the machine can be turned

as showed in the picture.

Do not place the inlet hose downwards.

Angle the hose to the left or right de-

pending on the position of your water

tap.

3. Set the hose correctly by loosening the

ring nut. After positioning the inlet hose,

be sure to tighten the ring nut again to

prevent leaks.

The inlet hose must not be lengthened. If it

is too short and you do not wish to move

the tap, you will have to purchase a new,

longer hose specially designed for this type

of use.

Note ! Check if the water connections are

tight.

Important! Before connecting up the

machine to new pipework or to pipework

that has not been used for some time, run

off a reasonable amount of water to flush

out any debris that may have collected in

the pipes.

Water drainage

The end of the drain hose can be posi-

tioned in three ways.

• Hooked over the edge of a sink using

the plastic hose guide supplied with the

machine. In this case, make sure the end

cannot come unhooked when the ma-

chine is emptying. This could be done by

tying it to the tap with a piece of string or

attaching it to the wall.

• In a sink drain pipe branch. This

branch must be above the trap so that

the bend is at least 60 cm above the

ground.

• Directly into a drain pipe at a height of

not less than 60 cm and not more than

90 cm. The end of the drain hose must

always be ventilated, i.e. the inside diam-

eter of the drain pipe must be larger than

the outside diameter of the drain hose.

The drain hose must not be kinked.

electrolux 23

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 51 52

Comments to this Manuals

No comments