Electrolux WAL7E300 User Manual download pdf (Page 8)

20

O

20

O

45

O

45

O

Make sure that the inlet hose

is not in vertical position.

3. If necessary, loose the ring nut to set

it in the correct position.

4. Connect the water inlet hose to the

cold water tap with 3/4" thread.

CAUTION!

Make sure that there are no

leaks from the couplings.

Do not use an extension

hose if the inlet hose is too

short. Contact the service

centre for the replacement of

the inlet hose.

3.4 Water-stop device

The inlet hose has a water stop device.

This device prevents water leaks in the

hose because of its natural ageing.

The red sector in the window «A» shows

this fault.

A

If this occur, close the water tap and

contact the authorized service centre to

replace the hose.

3.5 Water drainage

The drain hose should stay at a height of

not less than 60 cm and not more than

100 cm.

It is possible to connect the drain hose in

different ways:

1. Make a U shape with the drain hose

and put it around the plastic hose

guide.

2. On the edge of a sink - Fasten the

guide to the water tap or to the wall.

Make sure that the plastic

guide cannot move when the

appliance drains.

www.electrolux.com8

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 39 40

Comments to this Manuals

No comments