Electrolux GA55IEEV User Manual Page 93

  • Download
  • Add to my manuals
  • Print
  • Page
    / 100
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 92
The cleaning results are not satisfactory
The dishes are wet and dull No rinse aid has been used.
The rinse aid dispenser is empty.
There are streaks, milky spots
or a bluish coating on glasses
and dishes
Decrease the rinse aid dosage.
Dry water drop signs on
glasses and dishes
Increase rinse aid dosage.
The detergent can be the cause.
Technical data
Dimensions Width cm 54,6
Height cm 75,9
Depth cm 56,3
Electrical connection - Voltage -
Overall power - Fuse
Information on the electrical connection is given on the rating plate
on the inner edge of the dishwasher door.
Water supply pressure Minimum 0,5 bar (0,05 MPa)
Maximum 8 bar (0,8 MPa)
Capacity Place settings 11
Installation
Warning! Make sure that mains plug is
disconnected from the mains socket
during installation.
Install the appliance under a counter (kitchen
worktop or sink).
If a repair is necessary, the appliance must
be easily accessible for the engineer.
Put the appliance adjacent to a water tap and
a drain.
For the venting of the dishwasher only water
fill, water drain and power supply cable open-
ings are necessary.
Make sure that the water inlet hose, the drain
hose and the supply cable are not kinked or
squashed, when you insert the machine.
Attaching the appliance to the adjacent
units
Make sure that the counter below which you
attach the appliance is attached to a safe
structure (adjacent kitchen units, cabinets,
wall).
1. Set the appliance in front of the kitchen
unit. Put the mains cable and the hoses
into the recess unit.
2. Push the appliance in and pull the mains
cable and the hoses through. Make sure
that they are not kinked or squashed.
3. Align the appliance and attach it on the
two sides in the upper area of the tub.
Other attaching possibilities
1. On the plinth.
electrolux 93
Page view 92
1 2 ... 88 89 90 91 92 93 94 95 96 97 98 99 100

Comments to this Manuals

No comments