Electrolux 36 User Manual download pdf (Page 8)

Installing the hood

Installing prInstalling pr

Installing pr

eparationeparation

eparation

• The vent hood should be on site before final

framing and wall finishing. This will help to

accurately locate the duct work and electrical

service.

• Installation will be easier if the vent hood is

installed before the cook-top and countertop are

installed.

Ductwork and wiring locations:Ductwork and wiring locations:

Ductwork and wiring locations:

• Determine the exact location of the vent hood.

• Plan the route for venting exhaust to the

outdoors.

• Use the shortest and straightest duct route

possible.

For satisfactory performance duct run should not

exceed 100’ equivalent length for any duct

configurations.

• Refer to “

Ductwork installation guidelinesDuctwork installation guidelines

Ductwork installation guidelines” chart

to compute the maximum permissible length for

duct runs to the outdoors.

Ductwork installation guidelinesDuctwork installation guidelines

Ductwork installation guidelines

For safety reasons, ducting should vent directly

outdoors (not into an attic, underneath the house,

into the garage or into any enclosed space).

Keep duct runs as short and straight as possible.

Duct fittings (elbows and transitions) reduce air

flow efficiency.

Back to back elbows and „S“ turns give very poor

delivery and are not recommended.

A short straight length of duct at the inlet of the

remote blower gives the best delivery.

Transition to duct from the integral blower or

remote duct transition as close to the downdraft

as is pos-sible.

In order of preference, use

1st. 10" round duct

2nd. 8" round duct

3rd. 3-1/4" x 14" duct

4th. 7" round duct

5th. 3-1/4" x l0" duct

6th. 6" round duct

The use of flexible metal round duct should only

be used when no other duct fitting exists. Limit

use to short lengths and do not crush when

making corners.

• Install a wall cap with damper or roof cap at the

exterior opening. Order the wall or roof cap and

any transition needed in advance.

• Use 8" round metal ductwork only.

Removing the packagingRemoving the packaging

Removing the packaging

Remove the carton carefully. Wear gloves to protect

against sharp edges.

Remove the protective film covering the product

before putting into operation.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 18 19

Comments to this Manuals

No comments

Electrolux 36 User Manual Page 8

Comments to this Manuals

Related products and manuals for Fans Electrolux 36