Electrolux ERC3025X User Manual download pdf (Page 4)

OPERATION

Before using

Remove all securing tapes. Wash inside the

appliance with lukewarm water and bicarbonate of

soda (5 ml to 0.5 litre of water).

Setting the temperature

The temperature within the appliance is controlled by

the thermostat control knob situated at the top of the

appliance.

To operate the appliance proceed as follows:

Turn the thermostat control beyond the «

■» position.

Position min = minimum coldness

Position max = maximum coldness

Turn the thermostat dial to the required position.

The intermediate position is usually the most

suitable.

The thermostat setting can vary as the temperature

inside the refrigeration compartment depends on the

following factors:

– room temperature

– how often the door is opened

– how much food is stored

– position of the appliance

Fresh food refrigeration

To obtain the best performance, do not store warm

food or evaporating liquids in the refrigerator; do

cover or wrap the food, particularly if it has a strong

flavour.

Do not cover the shelves with any protective

material, such as paper, cardboard or plastic, which

may obstruct the air circulation through them.

To help you use your refrigerator correctly, here are

some more useful hints:

Raw meat (beef, pork, lamb & poultry or chicken):

wrap in polythene bags and place on the glass shelf

above the salad crispers.

Meat can only be stored safely in this way for

one or two days at the most.

Fruit & vegetables: these should be thoroughly

cleaned and placed in the bottom salad crisper(s).

Butter & cheese: these should be placed in special

airtight containers or wrapped in aluminium foil or

polythene bags to exclude as much air as possible.

Milk bottles: these should have a cap and should be

stored in the bottle rack on the door.

Control panel

A - Pilot light

B - Thermostat control

To Start the Appliance

Allow the appliance to stand for 2 hours after

installation.

Plug in the appliance and switch on at the mains

supply. Turn the thermostat control knob (B) to a

medium setting. The pilot light (A) will illuminate.

Leave the appliance for approximately 4 hours to

allow the correct temperature to be reached before

placing food inside.

To switch off the appliance turn the thermostat

control knob to position “O” .

Important

During prolonged periods of abnormally hot weather,

if the thermostat is set on too high a number, the

cooling system may operate continuously and the

fridge cooling plate may not defrost. Turning the knob

to a lower number will cause the automatic

defrosting to resume.

minMAX

Do not use soap or detergent as the smell may

linger. Dry thoroughly.

Door reversal directions

1. Disconnect from the electricity supply.

2. Gently lay the fridge on its back with the top held

away from the floor by 5-8 cm (2-3 inches) of

packing;

3. Remove the ventilation grill (D).

4. remove the bottom hinge (E) by unscrewing its

three fixing screws;

5. Slide out the fridge door from pin (G), unscrew

the latter and then refit it on the opposite side;

6. remove the two plugs of the door (where

available), discovering the holes for the hinge

pins, assemble them on the opposite side;

7. reassemble the door;

8. using a 10 mm spanner, unscrew the hinge pin

(E) and reassemble it on the opposite side of the

hinge;

9. reassemble the lower hinge (E) on the opposite

side, using the screws previously removed. Slide

the hole cover (F) out of the ventilation grille (D)

by pushing it in the direction of the arrow and

reassemble it on the opposite side;

10.refit the ventilation grille (D), clipping it into place;

11. Unscrew the handle. Refit it on the opposite side

after having pierced the plugs with a punch.

Cover the holes left open with the plugs supplied

in the documentation pack.

Important

After completion of the door reversing operation,

check that the door gasket adheres to the cabinet. If

the ambient temperature is cold (i.e. in Winter), the

gasket may not fit perfectly to the cabinet. In that

case, wait for the natural fitting of the gasket or

accelerate this process by heating up the part

involved with a normal hairdryer on a low setting.

D594

Rear spacers

In the bag with the documentation, there are two

spacers which must be fitted as shown in the figure.

Slacken the screws and insert the spacer under the

screw head, then re-tighten the screws.

1 2 3 4 5 6 7 8

Comments to this Manuals

No comments

Electrolux ERC3025X User Manual Page 4

Comments to this Manuals

Related products and manuals for Fridges Electrolux ERC3025X