Electrolux EOB9851XAX User Manual download pdf (Page 54)

7. After the end of the first part, empty

the grill- / roasting pan and put it on

the first shelf position again.

8. Press .

9. Fill the water drawer with fresh water.

Make sure there is no remaining

cleaning solution inside the water

drawer.

10. Insert the water drawer.

11. Press .

This activates the second part of the

procedure: Descaling. It will rinse the

steam generation circuit.

The duration of this part is

around 35 minutes.

Remove the grill- / roasting pan after the

end of the procedure.

If the function: Descaling is

not performed in the correct

way, the display will show a

message to repeat it.

If the oven is humid or wet, wipe it out

with a dry cloth. Let the oven dry fully

with the door open.

12.8 Descaling reminder

There are two descaling reminders which

remind you to perform the function:

Descaling. These reminders activate

each time you switch off the appliance.

The soft reminder reminds and

recommends you to perform the

descaling cycle.

The hard reminder obligates you to

perform the descaling.

If you do not descale the

appliance when the hard

reminder is on, you cannot

use the steam functions.

You cannot disable the

descaling reminder.

12.9 Steam generation system

- Rinsing

Remove all accessories.

Select the function from the menu:

Cleaning. The user interface will guide

you through the procedure.

The duration of the function is around 30

minutes.

The light in this function is off.

1. Put the baking tray on the first shelf

position.

2. Press .

3. Fill the water drawer with fresh water.

4. Press

.

Remove the baking tray after the end of

the procedure.

12.10 Removing and installing

the door

You can remove the door and the

internal glass panels to clean it. The

number of glass panels is different for

different models.

WARNING!

Be careful when you remove

the door from the appliance.

The door is heavy.

1. Open the door fully.

2. Fully press the clamping levers (A)

on the two door hinges.

A

A

3. Close the oven door to the first

opening position (approximately 70°

angle).

4. Hold the door with one hand on each

side and pull it away from the

appliance at an upwards angle.

5. Put the door with the outer side down

on a soft cloth on a stable surface.

This is to prevent scratches.

6. Hold the door trim (B) on the top

edge of the door at the two sides and

push inwards to release the clip seal.

www.electrolux.com54

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 63 64

Comments to this Manuals

No comments