The Selected delay set by pressing the
relevant button appears on the display for
a few seconds, then the duration of the
selected programme is displayed again.
• Alarm codes
In the event of operating problems, some
alarm codes can be displayed, for exam-
ple E20 (see paragraph «What to do
if...»).
•
Incorrect option selection
If an option which is not compatible with
the set wash programme is selected, the
message Err is displayed at the bottom
of the display for a few seconds and the
integrated red light of button 8 start flash-
ing.
•
End of programme
When the programme has finished three
flashing zeros are displayed, the pilot light
9 and the pilot light of button 8 go out
and the door can be opened.
7.2: Washing programme phase icons
•
Wash
•
Rinses
•
Drain
•
Spin
By selecting the wash programme, the pro-
gramme phase icons corresponding to the
various phases making up the programme
are shown in the bottom part of the display.
After having pressed button 8 only the icon
of the running phase stays on.
7.3: Heating phase
During the washing cycle the display shows
a temperature icon indicating that the appli-
ance has started the heating phase of the
water in the tub.
7.4: Soil degree icons
When selecting a programme on the dis-
play appears an icon indicating the degree
of soiling automatically proposed by the
machine:
•
Intensive
•
Normal/Daily
•
Light/Quick
•
Super Quick
7.5: Child safety lock
This device permits you to leave the appli-
ance unattended during it's functioning.
TABLE OF SYMBOLS
= Cold Wash = Door locked
= Rinse Hold
└ ┘
= Child Lock
= Night Cycle
FIRST USE
• Ensure that the electrical and water
connections comply with the installa-
tion instructions.
• Remove the polystyrene block and
any material from the drum.
• Pour 2 litres of water into the main
wash compartment
of the deter-
gent drawer in order to activate the
ECO valve. Then run a cotton cycle
at the highest temperature without
any laundry in the machine, to re-
move any manufacturing residue
from the drum and tub. Pour 1/2 a
measure of detergent into the main
wash compartment and start the
machine.
PERSONALISATION
ACOUSTIC SIGNALS
The machine is provided with an acoustic
device, which sounds in the following ca-
ses:
• at the end of the cycle
• if there is a fault.
By pressing the 4 and 5 buttons simultane-
ously for about 6 seconds, the acoustic
signal is deactivated (except if there is a
fault). By pressing these 2 buttons again,
the acoustic signal is reactivated.
CHILD SAFETY LOCK
This device permits you to leave the appli-
ance unattended and not to worry that chil-
dren might be injured by or cause damage
8 electrolux
Comments to this Manuals